0
Jack the car up and crawl underneath
Use proper safety stands!!
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
How do you reach fuel pump on 1998 Mercury Cougar?
You must remove the fuel tank in order to access the fuel pump.
Why would a car consume too much fuel?
Our 1988 Mercury Cougar with the 3.8 liter V-6 dropped drastically in mileage to an average of 10.5 mpg. I checked one of the oxygen sensors, located in the exhaust manifold, and it was filthy so I cleaned it with carburetor cleaner. Our mileage shot up to 18 mpg and the car is running better. I haven't gotten to the other oxygen sensor because it is in a difficult to reach place. I will be replacing both of them in the near future.
Where is the speed sensor on a 1996 Mercury Villager?
The Vehicle Speed Sensor on the 1996 Mercury Villager is located on the back of the transmission (as you look at the vehicle from the front) on top of the transmission with a pair of wires leading away from it... best to reach it from under the vehicle.
Where is speed sensor on a 1997 Mercury Villager?
Follow the transmission pan up and around front corner. It will curve upward slightly. Reach over this ear and you will feel the sensor wire.
Can you reach the oxygen sensor on a 1996 Plymouth grand voyager?
On a 3.3 or 3.8 you may have to remove the wiper cowling to access.
Why is it impossible to live on Mercury?
Mercury orbits the Sun closer than any other planet in the Solar System, so it is the hottest planet in the Solar System. The side facing the Sun can reach 427 degrees Celsius; the side facing away from the Sun can reach -173 degrees Celsius.
Where is oxygen sensor located on 89 jeep Cherokee?
The Oxygen Sensor on a 1989 Cherokee 4.0L is on the exhaust pipe on the left side of the engine just below the exhaust manifold. You can see it from above but you must replace it from below. It is pretty easy to reach. I recently changed mine and it took only 10 minutes using an O2 sensor wrench.
How can you reach the oxygen sensor of a 98 buick skylark for repairs?
The Oxygen Sensor or O2 senser, as it is sometimes called, is screwed into the exhaust manifold close to where it joins the exhaust pipe. You must jack the car or put it on a rack and get to it from under the car. If you are replacing it yourself you will need a crow's foot wrench.
How do Mercury and Neptune differ in temperature?
Neptune can reach way below freezing and Mercury can reach way above burning.
How do you remove the frame bolt on a 1999 mercury cougar?
Well, this just happened with my car and what I have to get done with it means that half the motor needs to come out to get to it. Well, for half of the motor to come out you have to take out the whole thing. Once you do that you can then reach the bolt and I'm sure you know where to go from there. but your gonna have to drop the motor to reach it.
Where is the oxygen sensor located on a 1996 Cadillac Sedan Deville?
the oxygen sensor is on the exhaust system located straight down from the firewall in the middle of the engine compartment you need a special socket tool like a line wrench because you have to go around the two wires that leads into the sensor, you also need long extension to reach the area, like a foot an a half extension with your ratchet.
The digital speedometer reads 0 MOST of the time. Where is the transmission speed sensor located on a 2000 mercury villager estate van?
The speed sensor is at the top rear corner of the transmission housing. It's a long reach from the top. There is one screw holding it down.
