i had the same exact vehicle. you don't release the tensioner, you'll have to take the presure off with a ratchet and socket. on the front of the tensioner pulley there is an arrow that has "loosen" next to it . get a socket that fits on the bolt in the middle of the pulley. ratchet the pulley towards the loosen side. there will be alot of tension so be careful. the belt will loosen when you turn it. slip the belt off the pulley and very slowly release the pressure off. it will pull against you alot but it will stop. just reverse this when putting the belt back on. also try to not take all the belt off if you don't have to, this will help w/putting the belt back on.
You can change the serpentine belt by loosening the tensioner pulley. When the tensioner pulley is loose and the serpentine belt will become loose. Put the new serpentine belt on and tighten the tensioner pulley.
You have to unscrew the tensioner bolt and remove the serpentine belt first, then change the pulley and replace the belt.You have to unscrew the tensioner bolt and remove the serpentine belt first, then change the pulley and replace the belt.
Loosen the tensioner pulley on your 1988 Chevrolet Corsica. When the tensioner pulley is loose the serpentine belt will easily come off. Put the new serpentine belt on and tighten the tensioner pulley.
Release pressure on automatic belt tensioner
Look in the engine compartment for the "serpentine belt" path & tensioner diagram. Release the belt tension at the tensioner, remove & reverse operation.
Loosen the tensioner pulley. Pushed the tensioner pulley to the left. The serpentine belt will come loose. Remove the belt. Reverse the process to install the new serpentine belt.
You will need to loosen the serpentine belt tensioner pulley on your 2002 Chevrolet Avalanche. Slide the belt tensioner to the right. The serpentine belt will become loose and can be removed. Reverse the process to install the new serpentine belt.
Use a 15mm closed end wrench on the tensioner pulley bolt and rotate the tensioner arm away from the drive belt. Remove the old belt and release the tensioner slowly so that it will not snap back and ruin it.
The ac belt has a tensioner that is accessed from below, and takes a tensioner tool to loosen. Remove the serpentine belt, release tension on the ac belt then the belt can come off for replacement.
Turn the Tensioner bolt clockwise (to the right)and the tensioner itself will move causing slack in the belt.
no, unless the tensioner is bad, other than that just the belt.
remove the belt. then in center of the tensioner is a bolt that goes into engine. remove this bolt. then tensioner should come off.