* Open the hood,raise the car and support it securely on jackstands and remove the front wheel.Disconnect the negative battery cable * Remove the cornering lamp from the fender * Pry out the plastic rivets,remove the screws and remove the inner fenderwell liner * Remove the fender mounting bolts * Detach the fender
In the passenger front fender. Remove wheel and fender liner to get it out.
It's on the driver's side on the back of the radiator. Difficult to get to unless you partially remove the inner fender well. Easier to remove the lower radiator hose on the passenger side.
You don't remove the fender; the battery is behind the inner fender well behind the rear driver's-side tire.
Remove the driver's side rear wheel; remove the inner fender well behind the wheel.
no
The fender on this truck is a simple bolt on part. Remove the screws that hold it on and unplug any wiring harnesses and it should come right off.
It is located in front of the left front wheel, inside the fender. You have to remove the wheel and fender liner to access.
In 91 the Tahoe was based on the S-10 so no they will not work. The fullsize SUV was labled a blazer but it was based on the previous platform so no they will not work with the later C/K platform.
What is the towing capacity of 1997 Tahoe?
Remove the Right wheel and inner plastic fender which will allow you access to the tensioner side of the motor. There will be a few bolts holding into place on the block. Remove the bolts and remove the entire tensioner assembly. Reverse for replacement.
It's a 1997 Tahoe