Want this question answered?
To remove the driver's seat on a 2007 Suzuki 800c Intruder you need to remove the headrest and remove the screws. Next, remove the bolts and washer on each side of the front of the driver seat.
How do you remove seats in a 2007 Camry SE
Move seat fully forward, remove side trim, remove seat belt retaining bolt, remove seat tracks rear bolts, flip seat upwards, disconnect wiring, remove seat.....
First you should move the seat completely forward. Then, remove the side trim, the bolt that holds the seat belt in place, and the rear bolts. Finally, lift seat, disconnect the wires and remove the seat from vehicle.
Remove the screw at the back of the back seat, then the two screws that hold down the front seat and there is your battery. Please remove the negative cable first.
If there is an access panel, yes. If not you will have to remove the tank.
The Battery is under the rear seat in a 2007 Cadillac dts. Remove seat by pulling up the front of the seat till it unlatches. This must be done on both sides. Battery is on passenger side.
4 bolts on each seat on the legs that bolt to the floor, take off and unhook any wiring to the seat that is under it and pull the seat out.
Remove the seat. The battery is under a cover right under the seat and next to the gas tank. Remove negave terminal first, then positive terminal. Release strap holding battery. Pull out battery.
First pull up the front of the seat bottom and release the retainer loopsSecond lower the seat backsFinally you should now be able to remove the bolts that hold the seat to the car
Yes
The lower part just lifts straight up. It is clipped in the front. The seat back is bolted in. You can get to the bolts after removing the cushion.