Move seat fully forward, remove side trim, remove seat belt retaining bolt, remove seat tracks rear bolts, flip seat upwards, disconnect wiring, remove seat.....
how to remove front bumper 2002 Impala
remove the four bolts at the front and the rear
Remove the headlamps and front bumper. Remove the three upper retaining bolts and the wheel arch liner. Remove all the bolts holding the wing in place and remove it.
Remove bolts from inside of glove dep. Remove bolts under defrost vent. Remove bolts from panels on side of dash. I think there is a total of 6-8 bolts.
The front fenders on your Land Rover Discovery are held in place with eight retaining bolts. Remove the retaining bolts and the front fender will come off.
Move the seat all the way forward, remove the 2 bolts on back of the rails, remove the side trim cover, remove the seat belt retaining bolt, tilt seat, disconnect wiring, remove seat. (See Haynes Repair Manual # 24047).....
Remove the tire and wheel from your 2001 Chevy Impala. Remove the end of the axle. Remove the wheel bearing nut. Remove the wheel bearing seal and the wheel bearing. Reverse the process to install the new front wheel bearing.
The Toyota Corolla front bumper is held in place with eight retaining bolts. Remove the retaining bolts and the bumper will come off.
Push in on the bottom of the seat front and then lift.
There are 4 bolts, 2 in front & 2 in back. You need the tool to remove the bolts.
Front or rear bumper? if its the front, all the lamps have to come out then remove the bolts from underneath.
The 1991 Honda Civic front bumper is secured by eight retaining bolts. Remove the retaining bolts. The bumper will come off.