There are 4 14mm bolts that hold the drivers front seat to the floor. Slide the chair all the way back and unbolt the 2 front bolts with a wrench or socket, then slide the chair all the way forward to reach the rear 2 bolts. With the chair all the way forward, pull the latch on the side of the chair that lets the back fold forward as much as possible. With the bolts out and the chair folded forward you should be able to turn and guide it out of the car.
The back seats on a 1994 Acura Integra are mounted on bracket that attach to the body of the vehicle. Push the back of the seat down and loosen all the bracket bolts. Pull the seats out.
90-93
You need to bolt the Civic seat rails to the Integra seats I believe. But yup, I got GSR seats in my CX. bolt them up
its physically inside of the fuel tank. You must remove the back seats to get to the little plate that has three screws and take that off to get to it
any 92-2001 integra will fit. also any Honda civic 92-2002 will fit also i believe
Trim level such as the interior, power windows seats ect.
How to remove front seats on 1971 vw Beatle
There are bolts that you must remove in order to take out the front seats of a 2002 Monte Carlo. There are two in the back of the seat and two in the front of the seat. If you have heated seats you will also have to remove the wires for that before you take the seat out.
The seats on a 1992 Acura Vigor use bracket which are found underneath and behind them. Loosen the bracket bolts to release the seats Pull them off and replace them.
it would be helpful if at least the model was given. i know in my 88 integra, all you have to do is push the buttons down on either side to let either the left half or the right half of the seats or both
remove the bolds to the seats. you will just have to look around for them. if i can remember right, they are in the front of the back seats, like the front lip, somewhere.
Use an axe