If the logo is screen printed, you will need a very strong solvent. I would start with Acetone and use a very wet towel and flip it frequently. You will undoubtedly leave a ghost image and distort the texture of the material. Vinyl spray paint can be purchased in your local auto parts store or hardware store, this could be used to even out the look after the logo is removed.
Good Luck
or go here and buy a blank one.
www.sparecover.com
Honda Logo was created in 1996.
An H is their logo.
H
Honda Logo has a tank size of 41 l.
You have to take out the bumper. Just take out the screws that are in the fender, take out the plastic cover that it is under the car that is attached to the bumper, take out the clips of the plastic grille with the Honda logo and pull the bumper. Don't apply to much force. When the bumper is out you will see the other bolts to remove the headlight.
The spark plugs are located under each igntion coil. The coils are located under the plastic engine cover with the 'i-VTEC' logo.
egle hook
Remove plastic cover with T-Mobile Logo from left side of unit to reveal sim card location.
Honda
1) Use a knife or a tiny screwdriver to carefully pry off the Honda logo. Try not to damage the rubber coating on the steering wheel or the logo itself. 2) Use a ratchet set to unscrew the nut behind where the logo was. I think it's a 15mm or 17mm, and you'll need an extension to reach it. 3) Pull the steering wheel straight off the steering column.
Yes, they have the Honda H on the headrest.
You need to remove engine cover first. Engine cover is the plastic cover with VW logo on it. The air filter is installed in the cover itself. You can find *very* good DIY info here: http://forums.vwvortex.com/zerothread?id=2547554