0
put your 9/16" wrench on one of the assembly bolts, get 5 or 6 big friends to pick-up the El Camino and turn it. u can pick the nationality or your choice for this job.
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
How do you install brake pads on a 1992 Aerostar?
# Release the parking brake # Remove the cowl trim panel from the left side of the drivers compartment for access to the parking brake pedal # Pull back on the parking brake cable toward the control assembly (parking brake) and insert a 5/32 inch drill bit into the control actuator to lock the assembly into position # Its actually easier to pull the parking brake cable from under the vehicle but you will need an assistant to help you do this way. # Loosen the rear wheel lug nuts and raise and support the truck # Remove the brake calipers and the brake discs # Detach the parking brake cable from the actuator arm # Clean the parking brake assembly with brake cleaner # Remove the brake shoe retracting spring # Remove the adjusting screw spring and remove the adjusting screw # Remove the hold down springs from the shoes # Remove the parking brake shoes from the actuator
Where is the parking brake switch located on a 1998 Chevy blazer?
On a 1998 Chevy Blazer, the parking brake switch is located on the top of the parking brake assembly. There are 3 bolts that hold the switch to the parking brake assembly.
How do you adjust the emergency or parking break on a 2006 Kia Spectra?
You can adjust your parking brake by turning the parking brake adjustment bolt. The parking brake adjustment bolt is located on the parking brake pad assembly.
How do you remove the parking brake pedal assy on a 1979 trans am?
Remove the side panel on the left front of the interior. The there is one bolt and one nut on the interior that you will remove. There are two nuts on the firewall underneath the brake booster that must be removed. After you remove, in total three nuts and one bolt, you can remove the parking brake assembly. Then just remove the cable. Done.
How do you adjust the parking brake on a 2001 Chevy Cavalier?
The 2001 Chevy Cavalier parking brake has an adjustment bolt on the parking brake assembly. Turn the adjustment bolt to loosen or tighten the parking brake.
How do I adjust the parking brake on a 2000 Chevy Impala?
The 2000 Chevrolet Impala parking brake will have an adjustment bolt on the parking brake assembly. Turn the adjustment bolt to loosen or tighten the parking brake.
Is there a manual parking brake release on a 1992 Cadillac Seville?
Yes, connected to the parking brake assembly is a little black lever, which when pulled will manually release the parking brake.
How do you change the Parking Brake Cable or adjustment for a 2001 Chevrolet silverado?
You will need to remove the rear rotors in order to access the parking brake adjustment. Chances are the parking brakes are completely worn down, and the rotors will need to be replaced. The 2000-2001 Tahoes are notorious for sticking parking brakes. The Tahoe utilizes a drum style brake pad located inside the hat of the rear rotors. There is a fairly tight tolerance between the parking brake and the drum portion of the inside of the rotor. There is a cogged nut that can be spun to adjust the diameter of the parking brake assembly. The following is likely the cause of premature parking brake failure. The driver side has a lever located on the inner part of the brake assembly. On the driver side the lever has a protrusion that can get stuck against the back of the brake assembly when actuated. The protrusion serves no purpose, and there is a Chevy TSB that recommends grinding it off.
How do you connect the front parking break cable to the parking break assembly on a 1993 ford f-150 4X4?
there is no front parking brake on a ford 4x4. the park brake is in the rear wheel brake assembly only ^ not what he asked The front cable does go to the back and on f150 93 and later theres no adjuster before the equalizer I think you have to remove the Pedal to get some slack im currently looking for the answer too
How do you remove parking brake lever from a shoe on Cavalier?
You can remove the parking brake lever, from the brake shoe on your Chevrolet Cavalier, by removing the retaining clip. The retaining clip connects the brake lever cable to the brake shoe.
How do you change rear wheel bearing 2004 Cadillac SRX?
You have to loosen the axle shaft nut first. Then you take off the brake caliper and bracket. Unhook the abs sensor wire. Remove the upper balljoint and then tap the axle shaft inwards with a piece of wood. Once it has cleared enough room, remove the bolts behind the hub. Loosen the parking brake bracket bolts and slip off the parking brake cable. remove the parking brake pads and the hub assembly should come with it if the axle shaft is not stuck in the middle of it. Reverse the procedure to put it back together. The parking brake can be a pain. Slip the end of it on as you are putting in the new hub with parking brake.
How do you remove and replace the parking brake assembly on a 1998 gmc sonoma?
I just went through this , forget it ! get the part from a junkie and have your mechanic replace it , not worth the trouble
