remove exhaust manifold remove intake manifold remove upper radiator hose remove ground wire at rear of head also the radiator hose bracket at rear of head remove valve cover, position crank and head at top dead center by aligning all arrows up crank up and upper pully on cyl1 and pointing up remove timing belt at this time now remove all 10 cyl. head bolts atarting at the front two now middle of head and work out in 1/4 turn amounts till loose. chears chaz g. sfv !
in the gas tank ?
behind the radiator,in the middle of the engine
-
The map sensor is on the air intake line to the throttle body....
The torque specs for the cylinder head on a b2200 are 59-64 ft lbs (cold).
yes you can its a straight swap you don't even have to change engine mounts
Was built with R12Was built with R12
Inside the blower motor housing directly behind the electrical coupler.
i own a 1990 fuel injected b2200 they didn't make very many but some of the 90-93 are injected.. finding parts are expensive and used parts for the motor are impossible to find
All the 1986-1993 mazda b series trucks were manufactured in japan.By the way great built trucks for that matter.
Next to the finiginn pin under the fly cap. A special tool is required to remove the fly cap, available only from the dealer. Ask for a springcock erection tool.
it should be near the gas tank above the fram rail