Want this question answered?
To remove a crank shaft pulley you need to first jack up the car. Next, remove the bold holding the crack shaft pulley in place and remove the unit. Reverse direction to put the new crank shaft pulley on your car.
Honda Crank Pulley Tool 50mm. The part number is 646796 at DenLorsTools.com. There is a video that shows it in use.
To replace the rear wiper motor, remove the wiper arm from the rear windshield of the Honda Odyssey. You will then need to remove the motor cover and the shaft nut. Next you need to remove the paneling from the inside of the rear hatch; this gives you access to swap out the motor.
disconnect the battery, remove the bolt in the center of the pulley, then use a harmonic balancer tool to remove it
A crank shaft position sensor on a 1998 Honda Accord reads whether or not a the engine is spinning correctly. If there is a discrepancy on how the crankshaft is spinning the sensor will relay it to the ECU.
crank shaft sensor or(ckp) is look like a simple sensor.its color is black.its lenth is two inches.GILL G
12mm /19mm
install 3.8 Chevy impala crank sensor passenger side , remove wheel and use pully to pull out crank shaft
Unbolt it at the shackles, and pull it out from the output shaft.
I would recommend that you do put a crank shaft head on a crank shaft. Putting any other type of head on a crank shaft could possibly break the head.
you get a gun and you shot it till its removed
For 3.5l, remove starter.