# Open the tailgate. # Remove the two screws from the tail lamp assembly. It should be obvious which two as the others clearly are holding the tailgate on. Be careful not to drop and lose them.
# Remove the lamp assembly. There are two clips that hold it in position and if the thing sticks just gently work it out pulling straight back. Don't twist it. # Give a short partial untwist to remove the specific bulb holder with bulb (hint: the brake light is the top bulb). # Pull the bulb straight out (do not twist).
You will have to remove the gas tank. Remove the retainer holding the assembly in and remove the unit. It is far less problems if you install the module assembly.
You need to remove the vent window assembly to remove and replace the door glass
Drain the radiator. Remove the lower radiator hose from the motor. Unbolt the hose inlet, and remove the thermostat. Replace the thermostat and the inlet, the hose, and refill the radiator.
To replace a blower motor in a 2006 Chevrolet Colorado first remove the old blower motor. Then install the new motor making sure to connect all the wires.
Remove screws, remove light assembly, rotate bulb holder counterclockwise & pull out, replace bulb(# 194). Installation is reverse.....
Remove the 1999 Chevrolet Cavalier inside door panel. The mayor assembly will be visible. Remove the retaining bolts and wiring harness. Reverse the process to install the new mirror.
coloradofans.com pass it on.......
To replace the headlight assembly on a 2006 Jetta, remove the front grill. Then remove the headlight assembly by taking off the screws that secure it in place. Replace with new.Ê
To change the ignition lock cylinder in a 2001 Chevrolet Tracker, first disarm the air bag system. Then remove the clock spring assembly to be able to remove the old ignition lock cylinder and replace with a new.
How to remove starter assembly
unsrew the main bolt and pull
Automatic or manual.. That's a broad question