1 pull off the front decorative piece that holds it all together.
2 There are 2 bolts holding it in, one on the top right and one in the bottom left. Take those out. you need an elongated rachet to do this.
3 Disconnect the ground.
4 Put in your new wireing harness and do the opposite.
It isn't that hard, just have to look in the right places. It explains itself.
Check here:
http://www.ehow.com/how_4454057_install-stereo-Chrysler-sebring.html
== * Screwdrivers * Wiring harness adaptor * Chrysler radio mounting kit Step1 Pull the negative power cable from the battery. Secure the cable so it doesn't come in contact with any metal parts or the battery.
Step2 Remove the trim ring around the radio by pulling gently on the corner until the clips release. Unscrew the two mounting bolts, one on each side of the stereo, and pull the head unit out of the dash.
Step3 Disconnect the wires from the back of the head unit and set it aside. If you have the infinity sound system, unhook the single extra wire from the back. Connect the wiring harness adaptor to the old harness.
Step4 Secure the stereo head unit into the Chrysler mounting adaptor. Snap the wiring harness adaptor into the back of the new stereo along with the antenna wire. If the adaptor has a ground wire included, connect it to the screw at the bottom right side of the radio entry in the dash.
Step5 Slide the mounting adaptor into the Sebring dash and reconnect the negative cable onto the battery. Turn the radio on.
Step6 Test the speakers and controls of the new radio. Replace the two bolts at the front of the unit and snap the trim back into place
Here is a link that gives numerous vehicle diagrams http://www.modifiedlife.com/2005-chrysler-300-car-stereo-wiring-diagram/
Yes
Radio Parallèle was created on 2005-11-17.
MLB Network Radio was created in 2005.
Def Pen Radio was created in 2005.
A 2005 Chrysler Sebring does not have a distributor.
A 2005 Chrysler Sebring does not have a reset switch.
No, a 2005 Chrysler Sebring does not have a cabin filter.
There are four mounts on a Chrysler Sebring.There are four mounts on a Chrysler Sebring.
You remove the pan on the bottom to drain.You remove the pan on the bottom to drain.
The factory alarm is an integrated part of the computer system of the vehicle and can not be removed.
No.
A Chrysler Sebring does not have a reset switch. The fuel system is computer controlled with relays.
A Chrysler Sebring does not have an inertia or reset switch.
You need to remove the engine oil drain plug. It is on the bottom rear of the engine.
the 05 sebring is fuel injected so there is no carbuatr
To replace a thermostat on a 2005 Chrysler Sebring first drain the coolant from the vehicles radiator, the engine must be shut off during this repair. Then follow the main radiator line to the thermostat housing. Remove the housing and replace the thermostat inside. Refill the coolant.