on the mk 1 avensis, if you lift the bonnet , the headlight and indicator frontlens separate
as modules. if you look at the top of the lights there are a couple of screws for the main
head light, but there is a screw that has a hole that is oval shaped, it also has a symbol
of a light and numbers 1.2% on my car you have to do is slide a flat blade screwdriver
through the oval hole, down the side of the screw, to push a plastic clip. if you look in side
you can see a bit of a groove. at the same time you pull the indicator lens forward
How to change bulb behind switch of fan Toyota Avenses
changing rear light bulbs on toyota avenis
http://wiki.answers.com/Q/How_do_you_replace_the_offside_headlight_bulb_located_on_a_2004_Toyota_avensis"
Mainly two reasons - the bulb is not working - the fuse is not working
Yes there is a separate bulb.
if this is the one on the bumper, you can access it from the bottom of the bumper. turn it as if you are loosening it. it should come out. if this is the one inside the cluster panel, remove the cluster and see which bulb it is. you should find this bulb at a parts store or a Toyota dealership.
Pull away the black plastic cladding in the back rear corner of the trunk that covers the rear light housing, the turn indicator bulb is the bulb closet to the side of the car, turn and pull the socket and bulb out of the housing, turn and remove the bulb to remove from socket.
Put a flat head screwdriver behind the indicator cluster and prize it out. Then just twist out the bulb.
Take out the side indicator light assembly (which is most difficult part) and then replace the bulb.
Toyota Yaris wing indicator/repeater is seal unit (it can't be opened), you have to replace the whole thing.
Begin by removing the connector from the back of your VW drivers side indicator light. You can remove the light bulb by pushing it in and turning at the same time. Reverse the process to install your new drivers side indicator light bulb.
The Peugeot 206 is a subcompact car. One has to remove the full light to change indicator bulb. A spanner can be used to remove the light cluster. Break the spanner off, and rebuild.