Go to the part store and rent or buy ball joint tools and press them out
You have to change the upper control arm.
the whole upper control arm has to be replaced.it is not that expensive of a part but you will need an alignment afterward.
Tie rod, ball joint or Strut.
it makes a farting like sound
The answer given is to remove tie rod ends... You need to get a ball joint press to remove them. Its not a hard job, but I would recommend getting a haynes or chiltons manual that can show you the process step by step I would advise you to mark the threds on the rod . Each ot the ball joints will be held by a nut with a carter pin remove the pin and losen the muts and screw the the ball joint off of the shaft and replace the new one to the place where you have marked the the new ball joints should come with new pins and nuts I would further advise to change the entire lower control arm which last i did one (last week) only cost around 65 bucks, this includes the ball joint and bushings on the arm. much better investment and ultimately easier to do (no ball joint press needed)
Disconnect the electrical connections and remove the 4 bolts.
Unfortunately you have to remove the tank, siphon as much as you can and then remove the tank.
Mark where the wires go, disconnect the wire connector, remove 4 screws and remove. Reverse the procedure to install.
special tool search eBay
Unbolt the hold down rod and disconnect the cables.
Disconnect the battery, and remove the electrical connection and remove the bolts, and reverse to install.
we used to drill a hole in top of all joint on top a a arm and insert self tapping grease (zirc )fitting some of them have a screw already all you have to do is insert grease fitting the answer is yes