# you have to remove engine cover # locate coil (follow wire from cap) # the bolts are on the bottom of the coil there are two (2) # if you use a ratchet and an extension with a 7mm socket you can reach them # if they are stuck or the bolt spins with the nut there is very little room to get a wrench on the bolt head just take the socket (shallow works better) and the extension put it on the nut and push it side to side snap off bolt nut end and then push the rest of the bolt through with a nail or something like a nail # new nuts and bolts that will fit and work just as good are about 25 cents (hardly worth the trouble of fighting the old ones out) And remember it's still CHEAPER to do it yourself even when is seems like hell at the time
1, 6, 5, 4, 3, 2.
It is advisable to have the ignition coil grounded on a 2003 Chevy Astro. This should especially be done when you are working on spark plugs and wires.Ê
On top of the RH Side of the Engine. You will need to remove the engine cover from the inside of the van to get to it. Just trace the coil wire from the distributor.
`on the right side of engine in the center of engine
take it to the dealer.
if the coil is on the distributor cap,remove cover then disconnect wires from the coil and remove coil. if coil is on engine then loosen the bolt and remove from coil mount
yes, they are in the distributor. Take the cap off, remove the rotor and there it is. The problem could be a bad coil
No electrial spark or fire at the plugs.
hope this helps.
Its right above the ignition coil. Infact you have to remove it first to remove the ignition coil.
Plug wires are installed incorrectly.
Underneath the coils. Remove the plastic head cover, Lossen all the coil pack bolts and fasteners, remove the coils and you will see the sparkplugs in the holes you just uncovered.