answersLogoWhite
Jeep Liberty Sport

How do you remove a door panel of a 2002 Jeep Liberty?


Top Answer
User Avatar
Wiki User
2015-07-15 21:30:18
2015-07-15 21:30:18

It's not impossible at all, its just takes some patience and some trust in yourself. All you have to do is remove the two screws that are located 1)Inside the doors armrest area and 2)Under the little cap covering the other under the door handle. You may want to use an flat screwdriver to remove the cap. When you remove those two screws start working your way around the edge of the door(where the plastic meets the metal) with a wood putty knife or something wide and flat. DO NOT TRY TO PULL FROM THE ARMEREST AT ANY POINT!!! Yes it will break off!!! When you begin to work your way around, feel for pressured areas. These areas have plastic fastners that hold the door panel on and help keep it in place. But when you remove them, you'll hear a loud "pop" noise. Its the fasteners coming out of their holders. On the front drivers side there are about 9 to 10 of those fasteners and two sliding fasteners at the top. On the passengers front panel there are No sliding fasteners and about the same amount of pop fasteners.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.