The dealer has a special tool for that.
you call someone
Take the nut off at the bottom of the light fixture by unscrewing it.
You'll need a special fixture and a press. Check with a local engine builder to see if they will do it for you.
You can remove the entire headlight fixture by removing 2 clamps on the back side. Pull entire fixture forward, turn over and drill 2 or 3 small holes on the bottom side of the fixture toward the rear of the fixture.............
You just have to unbolt it. However, it may be possible that you'll have to remove the engine from the engine compartment in order to do this.
Disconnect the fixture wires and remove the central mounting nut to release the dome from the light fixture in a ceiling fan.
Remove the socket from the rear of the fixture, remove faulty bulb from socket and replace with good bulb and replace socket in fixture. Fini!
On a 307sw THERE IS A RUBBER BULB AT THE BACK OF THE ENGINE( REMOVE THE PLASTIC COVER ON TOP OF THE ENGINE FIRST BY LIFTING UPWARDS ) SQUEEZE THIS SEVERAL TIMES TO BRING THE FUEL THROUGH TO THE ENGINE.
lifting eyes or you can thread bolts into head or block at opsite corners to hook chain to.
If you mean lifting the engine as in removing the engine for repairs, the answer is no. You can support the transmission with a jack or blocks and remove the bolts holding the transmission and engine together. It usually is much more difficult to remove both components at the same time, due to the extra weight and trying to balance them without having to raise everything to an unsafe height. make sure you unbolt the torque converter from the flywheel. makes it that much more easier
The tail light lens on a 1989 Chevy Celebrity is part of the tail light fixture and cannot be conveniently removed. If you want to change a light bulb you have to remove the tail light fixture from the car. To remove the tail light fixture: 1. In the trunk next to the quarter panel are three nuts, remove the center nut. It should be in the center of the tail light fixture. 2. Pull the tail light fixture so that the stud comes out of the body, then pull outward to pull the tab out of the backup light fixture. 3. You can now take the appropriate socket out and replace the bulb. Reverse the steps to replace the light fixture.
The G8t engine? You are not going to like/believe this.... you need to remove the engine (bu lifting the car off it using a 2 post ramp) to remove the manifold. French design! It is just possible to remove pre-heaters & injectors with the manifold, and the engine, in situ. But any more than that - no.