answersLogoWhite

0


Best Answer

On a 07 NBS with manuel door locks and windows, there are 3 covers that pop off. A very small one on the unlock/lock which allows knob to be pulled off, underneath the door handle and finally underneath the lever which opens the door. Under the last two covers mentioned are three 10mm bolts which have to be removed. The crank for the window aslo has to be removed. If you press in on the door panel you can see a small U shaped key which holds the crank on. Take something very slim and and pop it out of its groove and it should slide right off. Now all you have to do is gently pry and pop the panel out. All that's left is the cable that's attached to the lever used to open the door. Press on the sides of the small black clip attached to the cable and it should push downward freeing the door panel and allowing you to take it off completely.

On a 07 NBS with manuel door locks and windows, there are 3 covers that pop off. A very small one on the unlock/lock which allows knob to be pulled off, underneath the door handle and finally underneath the lever which opens the door. Under the last two covers mentioned are three 10mm bolts which have to be removed. The crank for the window aslo has to be removed. If you press in on the door panel you can see a small U shaped key which holds the crank on. Take something very slim and and pop it out of its groove and it should slide right off. Now all you have to do is gently pry and pop the panel out. All that's left is the cable that's attached to the lever used to open the door. Press on the sides of the small black clip attached to the cable and it should push downward freeing the door panel and allowing you to take it off completely.

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you remove a door panel on a 2007 Chevy silverado?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you remove an extended cab door panel on a 2007 Chevy silverado?

There are three places where the door panel has screws that need to be removed. You also need to remove the window crank and any other hardware that is external to the panel.


How do you remove the radio in a 2007 silverado to put the xm satellite in?

Begin by removing the decorative radio cover in your 2007 Chevy Silverado. Remove the radio retaining screws. Slide the radio out and remove the wiring harness.


Where can you find a Fuse panel diagram for a 2007 Chevy silverado?

I need a fuse and relay pannel diagram for my Chev. Silverado, 2007, 5.3 V-8 flexfuel LT package


What do symbols on dash board mean on a 2007 Chevy silverado?

what does check air bag mean on chevy silverado 2007 truck


What is the tow rating of a 2007 Chevy Silverado with a 4.8 liter engine?

Can I pull a 26 ft RV camper with my 2007 chevy silverado 4.8 motor


How do you remove the dashboard from a 2007 Chevy Silverado?

It will easily snap out with a flat head and work from one end to other removing it carefully.


How much is a 2007 Chevy Silverado worth?

"A used 2007 chevy silverado can be worth anywhere between $13,000 and $20,000. It will depend on the condition and mileage of the specific vehicle."


Is there a fuel cutoff switch on a 2007 Chevy silverado?

No.No.


Where is the oil plug located for a 2007 Chevy Silverado ext cab?

"Where is the oil plug located for a 2008 Chevy silverado ext cab?"


How do you remove the interior door panel from a 2007 Chevy Trailblazer?

The interior door panel is held in place by 10 retaining clips and two screws. Remove the screws of which can be found by the door handle. Pry outward on each retaining clip to remove the door panel.


How do you remove rear door panel on a 2007 Ford Escape?

how do you remove door panel on 2007 ford escape


What is the HP for 5.3 vortec in 2007 Chevy Silverado?

315 hp