Want this question answered?
Should be 4 bolts (one in each corner) Should be 4 bolts (one in each corner)
Not sure but i believe if you remove the drivers side rear tire you can see the corner of the fuel tank and the fuel filter. Looks like a very small tube about a two inches long. It is this way on my 91
If you are talking about the rear taillighs only the corner lights have bulbs pull back the inner trunk liner at the corner behind the light grab the grey or white plug and twist to remove the bulb the rear tailights on the trunk have no bulbs they are neon and if it is out the whole light assemble must be replaced
Remove the bolts !
Look inside the trunk under the light for bolts to remove the light.
Actually its quite easy. First open the hood and remove the plastic shroud cover that covers the headlights, a/c condenser, and radiator. It works the same way for both left and right headlights. Now, start with the corner light/turn signal light. The corner light has to be removed first before you can get to the headlight for removal.You should see a small arm that attaches the corner light to the headlight. Remove the small screw that attaches the small arm. I don't know the proper name, but the corner lights have little round metal ball shaped plugs on the back that insert into holes to hold the light in place. You have to dislodge the corner light from these inserts. Don't worry, its easy to do. Now that you have the screw removed from the small arm, now go to the outside of the vehicle to the corner light. Insert a flat blade screwdriver or something similar behind the corner light and gently pry it straight forward. If you use a screwdriver or other metal instrument you might want to tape it or cushion it in some fashion so you don't chip or mar the paint at the edge of the corner light's location. Now, with the corner light removed, you now have complete access to all of the mounting screws for main headlight. That's all that's to it. Naturally if you are going to remove the headlights, you need to disconnect the bulbs from the headlight housing.
Remove the wiring harness. Remove the light bulb retaining nut. Take hold of the light connector, push in and turn at the same time.
Remove the inside door panel of your 1994 Chevy Lumina. Remove the door handle linkage. Remove the door handle retaining bolts. Reverse the process to install the new door handle.
The 1994 Toyota Camry emergency brake light switch can be found beneath the drivers side dashboard. The emergency brake light switch will be beneath the far left hand side of the dashboard.
For the 1994, you have to remove the negative battery cable, then depress the brake and hold it in for 5 seconds to reset the check engine light.
under the hood,drivers side in the electrical control box
The 1994 Ford Probe has a brake fluid reservoir that should be mounted on the drivers side firewall. Remove the cap on top to add fluid.