a- Locate and remove a screw at the bottom of the central console behind the ashtray; you may need a flashlight to spot it.
b- Pull out the bottom while gently pry out the console cover sides; when doone you´ll see 4 Philips screws holding the CD player.
c- slide out the unit, carefully remove the rear conector: press a small tab and pull out, then the antenna.
It wasn't equipped with any from the factory.
Remove the cover from your 2003 Kia CD player. Remove the CD player retaining screws. Remove the wiring harness from the back of the CD player.
The factory storage location is specified as the glove box.
use your hands Xd
The only direct fit is the factory size.
Remove transmission oil pan
alarm always goes off until i put keys in ignition
you must first detatch all wires
You will need to remove the fuel tank.You will need to remove the fuel tank.
Air tools and PB Blaster.
You have to remove the transmission oil pan to access the filter.
Remove the wiring harness from the 2003 Jeep Liberty pressure switch. Remove the power steering pressure switch retaining screws. Reverse the process to install the new power steering pressure switch.
See this thread, located here: http://wiki.answers.com/Q/How_do_you_remove_a_stereo_from_a_2002_Jeep_Liberty
If you're looking at the car from the front left
Remove the decorative cover from your 2003 Lincoln Navigator CD player. Remove the CD player retaining screws. Slide the CD player out. Remove the wiring harness from the back of the CD player.
A 2003 Liberty does not have a cabin filter.
2003 AXA Liberty Bowl - 2003 TV was released on: USA: 31 December 2003
under passenger seat in right rear. loose nut from front side to remove.
The first step is to remove the outer trim surrounding the electronics panel; you can use a screwdriver to gently pry off the trim. There are a total of six clips holding the panel in place, two on top and bottom, and one on each side. Once the panel is off you can unplug the cables attached to the control knobs. Finally there are two screws on the bottom of the factory installed CD player, remove them and you should now have the device completely removed.
Fender flares on most vehicles, including the 2003 Jeep Liberty, are held together by pop rivets. Some vehicles might use a rivet that can be turned with a special square-tip screwdriver to remove it.
what is this code p1491 on 2003 jeep liberty
It is located behind the rear panel on the passenger side. You have to remove the entire panel to access it.