Locate the heater hoses in the engine compartment, follow them back to the fire wall, unhook both hoses at the firewall. The core is on the inside of the cab right behind where you unhooked the hoses. You will have to remove most of the lower dash board and the heater air box to access it. Not a very hard job, just a lot of BS to remove to get to it.
Are the door interchangeable on an 1987 chevy truck and an chevy blazer 1988
if its a 1987-1994 unhook the coolant tank unplug heater motor and 5 or 6 bolt off heater motor and you are done to put on reverse process
The heater core in a 1987 Chevy Celebrity is in the heater plenum to the right of the hump and below the glove compartment.
what alarme is it find the wiring digram and remove the fuse
I have a 1987 Chevy Blazer S 10 4X4 2.8l V6 and the timing recommendation is 10 degrees.
yes they are
A 1987 Chevy Blazer uses R12 refrigerant as shipped from the factory. Most have been converted to the more environmentally friendly R134a.
700R4
first you need to lift the hood and remove the two hoses from the back of the fire wall where the hoses are located. after you need to look under the dash board inside the car and remove all the screws and cover and then you will see the heater core. And the reverse will be the same. It will take a couple of hours no more than 3 hrs.
Doesn't have one.
tail gate
It is in the throttle body.