Want this question answered?
how to remove front bumper on citroen berlingo
remove Radio ,remove lower dash panel complete with glove box. remove heater box.
The heater matrix can be accessed from the front passenger side. Remove the glove box and the flow end return pipes for the heater matrix can be seen. You will need a fairly long T20. Torx driver.
The starter motor on a Citrogen Berlingo can be changed by first removing the electrical wires. Remove the three bolts that hold the starter in place. The starter will come out. Reverse the process to install the new starter.
Bypass the cooling system and discard altogether the heater matrix if you use the car below Rome.
Remove dash,centre console,heater box and you'll find it in there
There is no heater control valve fitted on a Ford Escort. The heater matrix is directly connected to the engine's cooling system. To reach the heater matrix, you should remove all the facia unfortunately... :(
To change a Citroen Berlingo bulb, disconnect the bulb from the wiring plug, and then remove the bulb holder from the headlamp light unit. While changing the bulb, make sure to squeeze the legs of the spring clip on the bulb holder together to ease its release. Afterwards, replace it with the new Citroen Berlingo bulb, and secure it with the spring clips without touching the glass. Lastly, put the bulb holder back into the light unit, and connect the wiring plug back into the bulb. After changing the bulb, always check to see if it s working.
Remove centre consul. Drain cooling system. Remove 2 heater pipes on bulk head under bonnet. Remove matrix cover in car under dash. Pull matrix out. This was on a 2002 model. As they say in the haynes manual..do in reverse to refit !
The brake light bald can be accessed through the trunk of the car. Remove the rear tail light cover to access the brake light bulb.
Remove cam covers,and do job doon as a leak could cause cambelt to come off,replace belt with new one
First, remove the wires. Then locate the nuts that hold the glowplugs in place and remove them. The glow plugs themselves can then be removed simply by unscrewing them. Then screw in the new glow plugs, replace the nuts and reconnect the wires.