Want this question answered?
What year? On 1961 Six cylinder, the front of the block behind the fan. Very obvious.
disconest the battery,remove the bolt in the adjuster arm then take out the 2 bolts from the gen. to engine gen mounting bar
what size fuzes and where do they go
12 volt
no frame uniboby Yes you have to remove the spot welds holding the roof and rear quarter panels, then remove the rear seat suport and replace the rocker panels as they are stronger than the ones on aq sedan. Then there is the front windshield you can take the ones from a convertable and weld them to the firewall ans dash metal being very carful as this is the basis for all the matching parts of the convertable this can be done as I did it to a mustang /unibody / and have replaced a rear quarter panel and roof on a falcon good luck and be patiant.
Yes Should have fuse block by steering column
Fowled Up Falcon - 1960 was released on: USA: 20 December 1960 Denmark: 11 December 1961
DX 2 is fine .
It is bolted to the side of the engine block next to the ignition coil.
Under the dash, directly under the headlight switch.
Out Front was created on 1961-04-04.
a c-4 will work