0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you open a keypad sentry safe?
A keypad controlled Sentry safe is opened by entering the correct code into the keypad. It prevents those without the correct code from opening it.
How do you get into gun safe with missing keypad?
Contact the maker.
How do you change from a combination lock to a keypad on a gun safe?
Basically by rebuilding the safe. Not practical to try this. Sorry
Unlock code tmobile motorola v360?
You can get an unlock code for your Motorola V360 mobile phone from the network lock by using an unlock code.You can get this code from Theunlockarena.com at reasonable price.
How do you increase the volume on Motorola v360 with a code?
i dont think you can
How do you you change a battery in a sentry V360 wall safe?
This is from the Sentry Web Site:How do I insert the batteries on my standard electronic lock?To power the lock, four alkaline AA batteries, are required.To install batteries:· slide open the battery cover located just below the keypad.· Insert a paper clip or pen point into the small hole in the cover.· Push in while sliding cover to the right.· Disconnect and remove the battery holder.· Insert the 4-batteries as indicated.· reconnect the connector and put back the battery holder.· Slide the cover back in place.
How can you obtain a replacement lock for a gun safe.?
If you don't know the manufacturer of your keypad, call the safe maker and find out. The electronic keypad (which is the most common point of failure) can be replaced easily at home. Find a replacement part on the internet (make sure it's compatible with your safe). You'll save hundreds. BTW upgrade to a Sergeant and Greenleaf keypad, they cost a bit more but are much more reliable than the no namers out there.
I forgot my keypad security code for nokia phone 1202-2 what should you do to reset?
I forgote keypad security code Nokia 2690 how can I remove old code
Why does my 2002 Ford explorer keypad not work How do I remove it from the door?
You might try reprogramming with original 5 digit code. Also might try looking for broken wires in the boot where the wires go between the door and the body of the car. To remove the keypad, roll the window down and pull the rubber/fuzzy moulding away from the top corner exposing three screws along the inside of window opening. Unscrew the screws and loosen and remove the black door pillar moulding with the included keypad. Should be able to unplug and remove keypad from moulding.
How do you remove the inner door panel on a 2001 F150?
http://www.svtlightnings.com/svt/how-to/keypad/keypad_install.htm
How long is the stand-by for the battery for the motorola v360?
The Motorola V360 flip phone features a Li-Ion battery that has a stand-by time of up to 240 hours. The talk time on this battery is up to 7 hours and 30 minutes.
Volume codes for Motorola v360?
volume codes for Motorola v360 Status Review Press menu and type 11 and press OK. Available Networks Press menu and type 13 and press OK. Preferred Networks Press menu and type 14 and press OK. Select Keypad Tones Press menu and type 22 and press OK. Require SIM Card PIN Press menu and type 25 and press OK. Language Selection Press menu and type 26 and press OK. Repetitive Timer Press menu and type 32 and press OK.
