0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where can you find the power sterring pressure sensor on a grand prix gtp?
The GTP does not have one it has Magnasteer which is all integrated in the steering rack & pinion which is controlled by the EBCM.
How do you remove 2001 Pontiac gran prix gtp?
remove what?
Is it ok to straight pipe your 2002 gtp?
yeah
How do you remove the entire ashtray in a 2003 Pontiac Grand Prix GTP?
how do you remove ash tray assy in 97 pontaic grand prix gtp sc
What makes your 1997 grand prix gtp hard to steer to the left power steering level is full?
When a rack & pinion steering system is hard to steer in one direction it USUALLY means that the rack is worn out. ................................ This issue is likely the failure of the lower pinion bearing in the GTP. This is a common failure in the 1997 due to a Chinese-made bearing that had improperly-crimped retainers, causing the balls to spill out of the bearing into the dust-cap at the bottom of your pinion. Seems to be a common problem after a tow. Check with your dealer to see if a recall for your specific vehicle is in effect (many were recalled). The part itself is very inexpensive (RockAuto charges less than $10 for it). Changing the bearing itself is also not extremely difficult (probably less effort than replacing the Rack & Pinion itself), and it is possible to do so without removing anything else (though it does require some flexibility and "engineering" skill). The dust-cap can be tapped off for inspection (it's at the bottom of the rack & pinion where the steering shaft connects). If there are bearings in the grease that has dripped into the cap, you have found your issue. One nut holds the bearing to the pinion, and a large snap-ring (which may also be damaged and a bit of a challenge to find (30mm)) must be removed. The outer part of the bearing will be somewhat difficult to remove. Snap-on makes a tool specifically for the job, however it requires the balls to have not fallen out, which in my case made it unusable. In my case, I custom-ground a two-legged puller out of a cheap 3-jaw pilot-bearing puller, ground down the ends to fit, and used it to pry out the outer part of the bearing. Replacement is much easier.
What kind of supercharger does the 2002 GTP have?
Eaton M90 Gen V
How many 2002 gtp 4 door were made?
and how many colors ?
What is the wheel size for the 2002 Pontiac grand prix gtp?
P225/60r16
What size motor does the 2002 Grand Prix GTP have?
3.8L V6 supercharged.
What is the tire size for a 2002 Pontiac Grand Prix GTP?
P225/60r16
How many 2002 grand prix gtp 75th anniversary edition did they make?
2000 Units
What is the best way to take the oil filter out of the Pontiac G6 GTP with the 3.6 engine bay from the top or from the bottom?
If it is similar to th 2002 i would remove the front passanger tire. I becomes extremely easy to access.
