Depending on the model, you have to first take two top brackerts holding rad (13mm bolts from memory) disconnect hoses, unbolt rad fan (couple of 8mm nuts, hard to get to bottom ones) if there is air con, care not to punture that rad, once done that the rad will gently lift out. It is very tight on space, and you have to be a little patient!!!
The thermostat is located on the front of the engine. Drain the water from the radiator. Remove the water hose. Remove the thermostat housing bolts. Reverse the process to install the new thermostat.
Remove the Fuel Tank
How do you bleed air from radiator of a 2000 range rover?
the easiest thing to do is remove the slave cylinder then pump the pedal and the fluid will pour out
check fluid level first if too low you will have air in the system and no heat check for leak or faulty radiator cap
Drain the water from your Corvette radiator. Remove the radiator hoses. Remove the radiator stabilizing arm bolt. Remove the radiator retaining bolts. The radiator will come off.
how to remove the transmission on 2004 Land Rover discover
Remove the water from the radiator. Remove the radiator hoses. Remove the stabilizing arm from the top of the radiator. Remove the radiator retaining bolts. Reverse the process to install the new radiator.
You can find a diagram regarding the installation of a replacement ball, on your Range Rover 400, at most Range Rover dealerships. Most auto-parts stores will have the diagram.
The Hydraulic clutch fitted to the rover 400 is a sealed unit and the only thing that you can do is to replace the complete unit
A few light taps on the end of the bolt, with a hammer will usually do the trick.
how to remove the transmission on 2004 land rover discover