Want this question answered?
you have to remove the lower engine splash shield to gain axcess to the fog light bulbs. you have to raise and support the veh to take off the engine splash shield
* Disconnect the negative battery cable * Raise the car and support it securely on jackstands.Remove the lower splash shield beneath the alternator and the right side inner fender splash shield * Remove the drivebelt * Disconnect the electrical connector and the alternator output wire from the alternator * Remove the engine cooling fan and shroud * Remove the air conditioning compressor mounting bolts (without disconnecting the refrigerant lines) and slide the compressor forward * Remove the alternator mounting bolts and remove the alternator from the engine
* Disconnect the negative battery cable * Raise the car and support it securely on jackstands.Remove the lower splash shield beneath the alternator and the right-side inner fender splash shield * Remove the drivebelt * Disconnect the electrical connector and the alternator output wire from the alternator * Remove the engine cooling fan and shroud * Remove the air conditioning compressor mounting bolts (without disconnecting the refrigerant lines) and slide the compressor forward * Remove the alternator mounting bolts and remove the alternator from the engine
* Disconnect the negative battery cable * Raise the car and support it securely on jackstands.Remove the lower splash shield beneath the alternator and the right-side inner fender splash shield * Remove the drivebelt * Disconnect the electrical connector and the alternator output wire from the alternator * Remove the engine cooling fan and shroud * Remove the air conditioning compressor mounting bolts (without disconnecting the refrigerant lines) and slide the compressor forward * Remove the alternator mounting bolts and remove the alternator from the engine
It's located at the front of the passenger front fender, inside the plastic splash shield. You would need to remove the horn to get to it.
Right front fender. Remove wheel and front part of splash shield. And probably the horn (you could just bend it out of the way)
According to Haynes manual...remove the wheel, remove the inner fender splash shield, turn the bulb holder counterclockwise and pull out.
Remove the splash shield from under the front of the engine. The oil filter is located at the left lower corner of the front of the engine
It's mounted low and to the rear (right side) of engine. You need to remove the splash shield and access it from under the car.
if its a v-6 remove the RF tire, remove the 4 10mm bolts on the inner fender shield and the clips that secure the rubber shield. this will give you enough clearance to remove the starter. remove the front splash shield and you can see the starter on the passenger side of the engine. remove the small wire, remove the large wire with a 12mm socket on a long enough extension to reach it from the bottom of the veh. The rest is acedemic, a couple of bolts and a little twisting of the starter it will come out right through the wheel well.
On SOHC 4 cyl engine the PCV valve is mounted in the oil separator on the left side of the engine. On DOHC 4cyl engine, it is necessary to remove the driver's side inner fender splash shield to access the PCV valve. The valve is just behind the coolant bypass hose near the hose clip.
easiest way is jack up the truck place a jackstand under the frame remove left front tire and inner splash shield if needed and remove the spark plug through fender well