Torx type? use torx screwdriver
Torx type? use torx screwdriver
A flat head screw driver to pop off the plastic cover, and a star screw driver to remove the whole thing.
Remove the set screw from the mirror, slide off.
remove grill by sticking screw driver down holes on the top , remove side light with star screw driver and remove the four 10 mm bolts (two at each side)
star = torx drive... and if it has a nub in the middle ( i didnt think cars had these) its a anti tamper type of screw..they sell torx with the nub out of the center
Clockwise to screw in, counterclockwise to remove
Remove the trigger assembly,Remove the sears, Remove the top lever spring, Remove the set screw for the lock, Remove the left hammer spring.
Remove the steering wheel, and you will see a white plastic, cam set up. There will be a screw holding the stalk onto it. Remove that, and the screws holding it in, unplug it.
hindi q alam
on the back side of hub,theres a rubber plug,remove,theres a star screw that separates your brake shoes,put screw driver on star screw and push down to separate brake shoes.it will help you take hub off,your brake cable might need replaced.
If you're asking how to change the condenser, it is under the rotor. Remove cap and rotor, remove condenser wire from contact set (either held in place with a screw or spring tension), remove the screw that holds the condenser bracket ( magnet or screw starter is very helpful), then reverse procedure to install new condenser.
In the back of the seat (both) you have a star screw bit that one you remove it you lift up on the back of the seat and the front will come up out of a groove that it slides into.