The starter is located at the front of the engine ( really the side part of the engine just beside the oil filter ) From underneath there are 3 large bolts to remove and some small ones. Disconnect the battery cables first, then disconnect the wires to the starter, then remove the unit. Look out for any shims ( small metal pieces that act as spacers ) between the starter and the engine. If there are none no problem. Re-install the reverse.
Disconnect the battery. The vehicle will probably have to be raised to reach the starter. The starter has two or three bolts holding it in, and wiring attached. Remove the wires remembering where to put them back. Remove the bolts and pull starter out.
open the hood, look down between the rad. and the engine. There it is.
if the starter is good , then its possible. do you know how to do it?
The starter solenoid is on the left side fenderwell next to the battery.
Mercury Topaz was created in 1983.
Disconnect the - battery cable Raise and support the vehicle Remove the wiring at the top of starter Remove starter mounting bolts Remove starter
Remove - battery cable Raise and support vehicle if needed Disconnect wiring at top of starter Remove starter mounting bolts Remove starter
Just look under the front of the car, just behind the rad. And there it is, if it is a 4cyl of course?
picture of the fan relay for 1993 mercury topaz
Disconnect the - battery cable Raise and support the vehicle Remove wiring at the top of the starter Remove starer mounting bolts Remove starter
starter motor is below and to the right of oil filter
Not quite sure what you are asking, but if you are changing the solenoid, then disconnect the battery first.