should just be able to open the tailgate and there should be two screws then the assembly should pop out
Lower tailgate and remove two screws. Pull assembly to the rear and it will release.
To change the brake light on a 2006 Acura, first, open the trunk and locate the tail light assembly. Remove the screws or clips securing the assembly, then gently pull the assembly out from the vehicle. Disconnect the electrical connector and twist the brake light bulb counterclockwise to remove it. Replace it with a new bulb, reconnect everything, and reattach the assembly to finish the job.
3 10mm bolts hold on the headlight assembly. Remove bolts and lift assembly slightly from the bottom to release it. Pull assembly forward. Twist marker light holder to remove it. Bulb pulls out. Reverse for installation.
To change the parking light on a 2006 Mitsubishi Outlander, first, open the hood and locate the headlight assembly. Remove the retaining screws or clips that hold the assembly in place, then gently pull the assembly out. Locate the parking light bulb socket, twist it counterclockwise to remove it, and replace the old bulb with a new one. Finally, reassemble the headlight assembly and test the new bulb to ensure it works.
To change the brake lights on a 2006 Renault Scenic, first, open the tailgate and locate the brake light assembly. Remove the screws or clips securing the light assembly and gently pull it out. Disconnect the electrical connector and twist the bulb holder to remove the old bulb. Replace it with a new bulb, reassemble the light assembly, and test to ensure the new brake light is functioning properly.
To replace the tail light assembly on a 2006 Nissan Titan, first, open the tailgate and remove the screws securing the tail light assembly using a socket wrench or screwdriver. Carefully pull the assembly out from the vehicle and disconnect the wiring harness. Replace it with the new assembly by reconnecting the wiring harness and securing it with the screws. Finally, test the new tail light to ensure it functions properly before closing the tailgate.
To replace the headlight assembly on a 2006 Jetta, remove the front grill. Then remove the headlight assembly by taking off the screws that secure it in place. Replace with new.Ê
The tail light is an assembly. The lens is not removable. To replace a bulb you remove the assembly by opening the liftgate, removing two fasteners, and pulling the light rearward.
To replace the fog light on a 2006 Pontiac Vibe, start by accessing the fog light assembly from underneath the vehicle. Remove the screws or clips holding the assembly in place, then disconnect the wiring harness from the old fog light. Replace it with the new fog light by reconnecting the wiring and securing the assembly back in place with screws or clips. Finally, test the new fog light to ensure it functions properly.
To replace the front driver’s side parking light on a 2006 Subaru WRX, start by opening the hood and locating the headlight assembly. Remove the plastic cover or the screws securing the assembly, and carefully pull it out. Disconnect the wiring harness from the parking light, then twist the bulb socket counterclockwise to remove the old bulb. Insert the new bulb into the socket, reconnect the wiring, and reassemble the headlight assembly.
remove the whole front end
You have to unbolt the entire soft bumper and remove. The dealer did this on my car to replace the headlight assembly.