How do you remove a tiger shark starter?

Answer 1

Just did it on a monte carlo 1000. Romove battery cables. Remove right side carb cover, Remove throttle cable and choke cable, loosen fuel lines/hoses at the carbs, remove the 6 bolts that hold the carb rail on, lift on the carb rail and remove the fuel line/hoses, then remove the center intake housing held on with 6 bolts, 10mm ratchet wrench, remove hot wire on side of starter, hold on to nut do not allow to drop becasue if it drops most likely it will go under the engine and good bye, once you have the wire off, remove the 2 bolts on the rear of starter, watch for the spacer between the sarter adb engine block, it will drop down but can be retrieved after starter removed. Now you are ready to pull out the starter. May need to pry on the starter front side and pull on the back it is o-ring seated in the fly wheel housing. Just keep working back to front until it pops out. Lift starter uop by the + post stud and bring up the side of engine where you removed the center intake housing. Throw away the old and in with the new in reverse order. If the starter bendix is bad rusty etc, you will have to pull the engine and I must note this is on a 1000 Monte Carlo I have.