You could pick the lock, just use a torsion wrench to hold the cylinder at the furthest it will rotate without the pins being released, use a pick to scrape them into place, and voila! You're all ready to shoot people.
A trigger lock is used for gun safety. It is a mechanism that goes over the trigger and locks to prevent the trigger from being pulled.
Remove the trigger assembly,Remove the sears, Remove the top lever spring, Remove the set screw for the lock, Remove the left hammer spring.
Generally a pistol lock fits in the trigger housing to prevent the trigger from being pulled. Usually takes a key to open and close it.
Raise the bolt arm, slide to the rear. Press the trigger and the bolt will slide part the lock and can be removed.
Note that the headrest need not be replaced in the event of deployment - merely reset.TSB09-80-0011.Remove headrest from seat and observe status of trigger lock. The trigger lock can be seenwithin the deployed headrest.If the trigger lock is unlocked, proceed directly to Step 3.If the trigger lock is locked, proceed to Step 2.2.Apply 12 Volts DC to the pin at A, while grounding the sliding shaft. At the same time push thetrigger lock by hand into the unlocked position. Disconnect power. The trigger lock will remain inthe unlocked position.3.Turn over headrest and lay down on aclean, flat surface4.Push the crash handle into the coverusing fingers5.Push cover6.Push cover until there is no gap.
To remove: Open action, press trigger rearward and pull bolt entirely from receiver. To install: Insert bolt in receiver, push bolt over plunger in bottom of receiver, pull trigger and complete forward travel of bolt; then rotate bolt handle downward to lock.
1996 rodeo- how to remove key from lock ignition?
Take it to a locksmith. Ummm...thanks tips. To get a trigger lock off yourself that you have lost the key for, you can simply drill out the lock mechanism (where the key goes). A drill press is the best for this. For the combo locks with a sliding cover, you can just hit the cover sharply with a hammer and it will break the lock mechanism, releasing the lock. These trigger locks were made primarily to keep kids fingers off guns, not for national security.
with a barrel lock key
tooks like a trigger Its dorsal fin looks liker a trigger and can lock into an upright position enabling it to secure itself into protective quarters like corals and crevices.
you have to remove the steering wheel then using a lock plate removal tool depress the lock plate and removed the clip that holds it in place then remove the lock plate then remove the screws from the turn signal switch and pull it up slightly then remove the screw that hold the lock cylinder in place then remove the lock assembly
best to pump to the trigger about 30-40 times then put the choke and trigger lock on and keep pulling when she fires up and the revs start to die turn the choke of but leave trigger lock on and slowley press in the trigger to build revs until warm. about 40 seconds for the whole procedure