Hello, how is health? I hope all is well with you, My name is Mirian, am a female. i will like to be your friend, I saw your profile today and you really captivated my interest, hoping to hear from you soon.with this my personal email address (mirianmurrey@Yahoo.com) i need an intimate love and caring man, From your Lovely one Mirian.
Solvent wax refers to solvents that remove wax. The solvent is able to dissolve, or get rid of, the wax.
Good luck with that. The best way is not to get any wax on the trim in the first place.
It depends on the type of tile you have. If the tile is unglazed and porous (as mostly all travertine is) then you will need to seal the tile before you grout it so that the grout does not soak into the tile and cause it to become dull. Follow the manufacturers recommendation for the tile that you have.
all wax is a base (and all your base belong to us)
Answermelt the wax and pour it out After melting the wax and pouring it out, immediately wash it out with hot soap and water, then you can also use a paper towel after drying it with a cloth towel to remove left over wax, if it don't come out, reboil your pot and rewash with hot soap and water until the wax is gone and dry.
Tile has a glass finish & doesnt need wax, Wax can cause a slip & fall hazard when it gets wet Sealing tile is a misnomer, you really only need to seal the GROUT.. stop by the Depot & get some grout sealer, better for the grout
You can remove all, or a majority of it, by placing an ice cube on the wax, then chipping it off the wax as it hardens from the ice.
To re-grout you mosaic tables, simply use tile grout. Be sure to remove the excess grout from the mosaic tiles to preserve the tables beautiful look.
It depends on the type of grout you used. Typical cement-based grouts cannot adhere to existing grout in lines of less than 1/8" deep, and it's advisable to remove all the grout and do over. If your grout is an epoxy-based grout, or some varieties of pre-mixed grout, it might be possible. Check the label to see if it adheres to existing grout, and at what thickness.
VERY difficult. -It's easier to paint over it with special grout paint.
grout removal and replacement is a hard and long project unless you already have the tools and knowledge, If you hire a tile contractor you are likely to spend anywhere from 2.50 to 3.50 a sq foot depending on the age of the grout and the thickness and width of the grout..........
You will need a grout saw and grout scraper to remove the old grout. Then use an epoxy grout meant for swimming pool use, and work in small areas at a time. Choose a color that matches the tiles. Follow the mixing instructions on the container. When all the tiles are properly filled wait for it to dry before finishing the job with a sealant.
Non Sanded grout can be used in any size grout joint but is ideal in smaller joints usually up to 1/4" The main draw back to using unsanded grout in larger joints is that it may crack over time. If you are unwilling to remove all the grout and use a sanded grout, it is best to make sure the grout is cured and sealed properly to limit and minimize cracking.
by adding acetone to it
To remove candle wax from a hardwood floor use an ice cube to harden the wax and then gently scrap off the wax with a putty knife. To remove the wax finish on a hardwood floor use mineral spirits on the floor. Use a cloth and apply the mineral spirits in a circular motion until all the wax has been removed.
Solvent wax refers to solvents that remove wax. The solvent is able to dissolve, or get rid of, the wax.
Well YA! That is how you do it!! :)