Want this question answered?
-There is no 2000 previa you must mean a 2000 sienna! The last year of previa was 1997 -Yes in North America, the last Previa model was in the year 1997 and it was succeeded by Sienna but aside from NA, the Previa is still in production (NZ-Previa, OZ-Tarago, Japan-Estima)- http://en.wikipedia.org/wiki/Toyota_Previa I own a 2000 previa model here in NZ.
remove the radiator, then remove 4 screws that holds the fan ,,done..
yes, you have. And change new seal too.
I would say NO as the lucida and estima and previa are all different in length and width if you can find replacment arms etc from eBay
Depends on year and model mine is the estima aeras 2000 v6 1fe az front three plugs are easy but you have remove the plenum to access the three rear plugs as they are impossible to get at
Remove the light assy then turn the bulbs countereclockwise to remove the bulbs.
On the 95 model previa/estima the turn signal relay is loacted just under the drivers side dash arae. Located on the right hand side of the footwell On my Previa 1996 UK spec i found the flasher unit at the back of the speedo.you need to remove the radio housing then you will need to remove two screws which hold the clock outer bezel,remove carefully.there are four screws holding the clock. When you have removed the clock wala you will see it in front of you. it took me a week to find it. they don't tell you where it is in the workshop manual. Good luck Ivor (imccann)
To remove the spare tire from a Toyota Estima, insert the jack handle into the hole provided in the rear bumper and turn clockwise. Turn counterclockwise to return the spare tire holder to normal.
open the hood remove the air intake funnel remove the base of the air duck and you will find the blower..
remove wheel, loosen bottom caliper bolt, swing caliper upward, remove hardware and pads, then reassemble in reverse order of disassembly.
# Raise vehicle. # Support the rear axle of the vehicle using 2 jackstands positioned at the outer ends of the axle. NOTE:If the shock absorber lower mounting bolt deflects upward during removal, raise axle by adjusting the support jack. If the lower shock absorber bolt deflects downward during removal, lower the axle by adjusting the support jack. # Remove the shock absorber lower mounting bolt. # While holding shock absorber, remove the shock absorber upper mounting bolt and shock absorber. # While holding shock absorber in position against the frame rail, install the shock absorber upper mounting bolt. # Install the shock absorber lower mounting bolt securing the lower end of the shock absorber to the axle. # Remove the support jack. # Lower the vehicle to the ground so the full curb weight of the vehicle is supported by the suspension. # Tighten the upper and lower shock absorber mounting bolt to a torque of 88 N·m (65 ft. lbs.).
Remove the passengers side front seat. remove the metal engine cover after pulling carpet back, remove the long metal cover covering the spark plugs and wires.