Inboard of either light is 2 screws, one high and one low, you can tell which ones are attached to the light assembly. Remove these 2 screws. Remove the screw on the very corner of the fender, it looks like it holds nothing, but it in fact is a mounting tab for the corner parking light. Pry the front of the parking light out away from the main light and it'll pop loose of the socket (it may be on pretty good, use the headlight as a pry point and use a screwdriver prying against a piece of cardboard or something if you feel the light will be damaged) then you pull it straight forward as it has hook like stays on the rear edge. Now you can work out the main light with back and forth rocking motion, itll eventually come loose and youll see a bulb harness on the backside. pull harness away looking for any locking tabs on the harness. Now there is a ring that holds the bulb in, turn it 1/4 CCW and the ring should come off and the bulb is now free to oull out. Dont touch new bulb with fingers, the oil will cause a hot spot and the bulb will fail prematurely, Assembly is opposite removal, Check your bulbs in the parking lights while you are at it, Sylvania #168 5W/12V.
Open the hood of the engine compartment to your 1994 Toyota Corolla. Remove the wiring harness from the headlight. Remove the headlight retraining bolts from the headlight assembly. Reverse the process to install the new headlight.
To remove the headlight housing (question is kind of vague, I have to assume this is what is being asked): Open hood & remove center grill. There are two bolts on each headlight housing on the inside, you will find them just behind where the grill was. Remove the two on the headlight housing you are trying to remove. Remove side marker light on the side you are removing the headlight from. You will find two nuts holding the headlight housing to the frame, remove them. Housing is now unbolted and can be slid out/off of the car.
# Remove the front bumper cover # Remove the upper headlight housing mounting bolt and pushpin # Remove the lower headlight housing mounting bolts # Pull out the headlight housing assembly and disconnect the electrical connector
To change the headlight on a 1985 Honda Spree scooter remove the headlight housing. The scooter headlight will be mounting on the rear of the housing. Remove it and replace the bulb.
Headlight Bulb Replacement * If your going to replace the left hand light bulb remove the air filter housing * Disconnect the electrical connector unless replacing the headlight housing * Rotate the bulb holder counterclockwise and pull it out the bulb and holder assembly Headlight Housing Replacement * Remove the front bumper cover * Remove the upper headlight housing mounting bolt and pushpin * Remove the lower headlight housing mounting bolts * Pull out the headlight housing assembly and disconnect the electrical connector
there are 2 torx screws where the headlight housing is mounted to the radiator support. Remove these first. They are 4 to 5 inches long so they have to be pulled after unscrewing them. Remove the housing assembly. Then unplug the wiring, turn the light and remove it from the housing. Install in reverse order. Make sure the aligning stud is inserted into the fender.
How do you remove the light housing for a 2006 scion xb
How to remove the headlight assembly # Disconnect negative battery cable # Remove the headlight bulb # Remove the radiator grille # Remove the parklight housing # Remove the retaining nuts and bolts and detach the housing and withdraw it from the vehicle
Gain access to the rear of the headlight housing. Remove the weatherproof rubber protective boot and remove the headlight bulb socket. Replace bulb and re-install in reverse order.
Disconnect the battery and open the hood. Reach the headlight from the back and disconnect the two wires. Remove clips holding the assembly. Remove the assembly carefully and set it aside. Install the new one.
To replace a headlight on a 2002 Honda Civic first prop the hood open. Locate the headlight housing inside the engine compartment. Find the bulbs and remove them. Install the new bulbs.
Before replacing the headlight bulbs on a 1997 Acura CL prop the hood open. Locate the headlight housing and remove the old bulbs. Install the new lights.