answersLogoWhite

0


Best Answer

Many Plymouth Voyagers have the J-hook wiper arm. A person has to bring the old blade up, push it down over the hook, and then up over the hook. Next put the new blade over the hook, push it down so the hook goes through the hole, and then back in to catch the bar.

User Avatar

Wiki User

9y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you remove and install wiper arms on a 1994 Plymouth Voyager?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How do you access backside of engine in 98 Plymouth Voyager?

If its like a 96 you remove the windshield wiper motor and assembly


Where is the relay for your rear wiper on your 1997 Plymouth Voyager?

On a 1997 Plymouth Voyager, the relay for the rear wiper is found under the hood. It is in the fuse housing on the passenger side.


Can you reach the oxygen sensor on a 1996 Plymouth grand voyager?

On a 3.3 or 3.8 you may have to remove the wiper cowling to access.


How do you maneuver and remove the alternator from a 1998 Plymouth Grand Voyager with at 3.3L engine if you have already disconnected it?

You have to remove the wiper cowl assembly, and the alternator mounting brackets.


How do you remove the wiper arm off a 95 Plymouth Voyager?

Not sure if the 95 and 99 Voyagers are the same, but on a '99 Voyager to remove the rear wiper arm, you have to lift a tab that is to the right of the circular cap. You have to raise the wiper arm off the glass then pry the little tab up. After the tab is raised, you can wiggle the arm off the wiper motor.


What would cause wiper blades to collide on a 2000 Plymouth voyager van?

Bent or misinstalled wiper arms.


What is Front wiper size for 1999 Plymouth Voyager?

28", I just replaced mine


How do you lift the Drivers side wiper arm high enough to change the blade on a 1994 Plymouth Voyager?

Just grab the wiper arm and lift, its only like spring loaded, just lift it, remove old wiper and replace.


What size wiper blades for a 1996-2000 Plymouth voyager?

All 1996-2000 Plymouth Voyagers take 28" replacement windshield wiper blades on both sides front.


Where is the front windshield wiper motor located in a 1997 Plymouth voyager?

Under the black cowling at the base of the windshield.


How do you troubleshoot the passenger wiper not working on a 2000 Plymouth grand voyager se?

Remove the door panel and check for power and ground at the motor connector. If you have both power and ground the motor has failed.


How do replace the rear wiper blade on a 1999 Plymouth grand voyager?

The 1999 Plymouth Grand Voyager takes a fairly standard 18" rear wiper blade (also takes 28" replacement windshield wipers on both sides front). Additionally, the installation process is simple. The replacement wiper blades will come with step-by-step, illustrated removal and installation instructions.