There are 2 VERY small allen screws under the housing. Remove them and turn the lens counter clockwise.
On an 02 There are 2 VERY small allen screws under the housing. Remove them and turn the lens counter clockwise.
I have a 2003 iron horse and had starter rebuilt , I'm wondering is there suppose to be a shim , it keeps blowing out my clutch
Open Hood. Remove the cover from the headlight by prying up the keeper. Remove the metric 13 nuts holding the headlight in. Take out headlight and replace the bulb. Reinstall the headlight and reinstall headlight and cover.
== == remove the three retaining ring screws wiggle out the old headlight ,reinstall the new head light put the retaning ring back on and reinstall the three screws.
Unlug the light harness, unscrew the plastic nuts, pull out the headlight. Reinstall new headlight, screw the plastic nuts back on and plug the light harness back into the the headlight housing.
ou have to remove the headlight assembly by removing the two screws on top and pull out the assembly. The screws will be long. After you remove the headlight assembly there is two sets of wires one for your turn signal and one for your headlight grab a hold of the headlight up close to the assembly and turn it. when you have turned it enough it should be able to come out then you put the new bulb in and reinstall everything.
I assume you mean HEADLIGHT LENS.. .. there are 3 bolts on the back, remove, pull out headlight. Remove clips and broken lens. Replace gasket, lens and put on clips FRONT TO BACK so you don't chip the lens. Reinstall with 3 bolts on back.
Open the hood & look for two white sliding clips. Pull them up to remove them. The headlight assembly should easily pull out. Identify the wiring harness & unclip it. Reverse the procedure to reinstall
You can remove the headlight by removing the retaining screws. Remove the headlight wiring. The headlight should easily come out.
Open hood. Remove wing nuts holding lamp assemblies. There should be two for the headlight and another holding the cornering light assembly. Careful when you remove the headlight assembly as you might have to lift a bit to pull it out. For the cornering light assembly, just pull towards front of vehicle. The turning lamp (which I think is what you are asking about) is a tiny little bulb that just pushes in and pulls out of its socket once you remove it from the assembly. No twisting required for the bulb. Reinstall cornering light assembly first. Tighten wing nut for that. Then reinstall headlight and two wing nuts for it.
Open the bonnet. Remove the grill. Remove the screws holding the headlight in. Carefully pull the headlight out. Remove the cap on the rear of the headlight.
How to remove headlight assembly on 2003 Lexus GX470