0
How do you remove and replace Window motor regulator on a 2000 intrigue?
Wiki User
∙ 13y ago
remove your door panel there will be three screws holding it on. then you have to remove the screws holding your window to the regulator. then unbolt regulator and motor from door. Undo wiring going to motor.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
How to Replace window motor in a 1999 suburban?
How to remove the window motor from the regulator
How do you remove window cable from 2000 Jeep?
You will have to replace the complete window regulator assembly.
How do you replace a rear window regulator on 2005 CTS Cadillac?
To replace a rear window regulator on 2005 CTS Cadillac remove the side protection panel of the car door then adjust the regulator.
How do you install a new window regulator on a mgzr drivers door?
To install a new window regulator on a MGRZ driver's door, remove the door panel and the wiring attached to the power window mechanism. Remove stereo speaker from the inside door and the window glass. Remove the old window regulator and replace with new.
How do you replace the electric window regulator in a 1999 Camry?
The panel where the regulator is detachable. You will be able to remove it very easily. When you remove the panel you will see the way how the regulator can be replaced.
How do you replace achieva power window motor?
Remove the window regulator assembly from the door.Remove the motor from the regulator by drilling out the attaching rivets with a 3/16 in. drill bit.Connect the window motor to the regulator with 3/16 in. rivets.Install the window regulator assembly.
How do you replace 1995 Toyota Celica power window regulator?
remove back seat, remove screws bottom and top of panel, remove panel. remove 3 bolts and motor arm, window and regulator will pull out.
How do you replace the automatic window motor and regulator for the drivers side window on a 1994 Jeep Cherokee Sport?
Remove the door panel. Remove the bolt that fastens the regulator to the window. Remove the 3 bolts that hold the regulator assembly to the door. Squeeze the entire assembly through the largest hole and replace with a new assembly in reverse order.
How do i change the right rear window motor on a 2002 deville?
It is best to replace entire regulator as one unit. Remove door panel. Remove bottom nut of regulator, and remove two top nuts of regulator. Loosen two bolts on bracket holding window. Support window, and carefully remove regulator as one unit.
How do you replace 3000 gt door window regulator?
First, lower window approximately half way. This allows you access to the bolts that attach window to the regulator. Remove door panel. Using a 10mm wrench, remove the two bolts that hold window to the regulator. Then there are two upper and two lower bolts holding the regulator to the door. Then you remove the three bolts for the window motor which is toward the front of the door. You have to also disconnect the plug for the windo motor to remove the entire window regulator and motr that are all one unit. Replace the unit in the reverse way.
How do you replace window regulator 1991 3000gt?
Take the door panel off,you will need to remove 3 bolts for the window motor and then 3bolts(maybe4) that hold the regulator to the window
How do you remove an explorer back side door panel to see why window will not hold up?
You must remove door panel and replace window regulator.
