Hey Steve==If you have to ask, you must not be very familiar with mechanics. First drain the radiator. Take the fan shourd off then remove the hoses, and oil cooler lines. Then remoove the bolts and pull the radiator out. Reverse operations to install. GoodluckJoe
Remove the cooling fans then take the hoses off and the cooling lines off. Then remove the bolts that hold it on and take it out.When you remove the lower hose catch the coolant in a drain pan and dispose of it correctly.
its easy once you know the secret. The plastic cover around the shifter just pops of if you grab the lower part of it and lift up. Then remove the center ac knob an d remove the screw behind it. Then you can pry the whole center part out startign from the bottom again and pulling outward. remove the plugs from all the switches and the clock and then there are 4 ten mm screws that hold in the radio and the two ac vents. remove them and pull the radio out. That's it!
To just remove the coolant from the radiator, there is a plug or valve at the bottom of the radiator on either the left or right side. Loosen this and drain the coolant into a container---NEVER ON THE GROUND-IT IS DANGEROUS TO ANIMALS AND IS TOXIC.
Tighten the valve when empty and refill. Run the vehicle to get it to operating temperature and keep filling until all of the air is out of the system.
Its a pretty easy ob. Most radiators have 2 or 4 bolts holding them in and either a fan shroud ( for engine driven fans ) or an electric fan bolted on to them. Remove the upper and lower radiator hoses, unbolt the fan shroud ( move it back toward the engine ) or remove the electric fans and remove the mounting bolts for the radiator ( the last one I did had 2 bolts at the top and just 2 pegs at the bottom ) and pull it out. Install in reverse order.
Be sure to dispose of your used anti freeze appropriately as it is a poison and always mix it 50/50 with water, never run just water in your cooling system. Its a good idea to replace the thermostat at the same time.
At autozone.com they'll provide you with diagrams and instructions. First look for the item, in this case a radiator, and the list will appear along with a link on how to removal and install.
major steps in planning
Mr. Muggs Steps Out was created in 1943.
8 steps up- After this action, the man is now 8 steps above the middle.12 steps down- The man is now 4 steps below the middle.1 step up- The man is now 3 steps below the middle.9 paces to the top, 3 steps per pace- This means 27 steps have been climbed to reach the top, from 3 steps below the middle. Therefore, from the middle, there are 24 steps to the top.If half the steps equals 24, then all the steps equals 48 (24 * 2).
Heartbeat - Steps song - was created on 1998-11-06.
Five half-steps make a perfect fourth.
call birdman
disconnect neg.battery cable. disconnect wires from alternator. loosen pivot and lock bolts. detatch drive belt. remove pivot and lock bolts from the bracket. installation is reverse of these steps.
first drain all anti freeze out of your radiator then undo fan shroud. Next you will have to undo radiator hoses supply and return, then undo the four bolts holding the radiator in once bolts are out just slide it right out the top. TIP: when putting radiator hoses back on or taking them off spraying WD-40 inside the hoses will make putting them back on or taking them off easier. To put radiator in repeat steps backwards.
cant find the capacity in the manual- but- heres some steps,,, refilling-put heaterin max position, add 50/50 until radiator is full, fill reservoir to the lower mark, leave radiator cap off and run engine until thermostat opens(upper radiator hose becomes hot), cut off engine and let cool, add more 50/50 to the radiator up to the lip on the radiator neck, squeeze the upper radiator hose to get rid of air, replace radiator cap. start engine and check for leaks. The coolant capacity for my Toyota corolla 2ltr diesel 1994 is 1.5 litres and 1.5 litres of water,so in total 3 litres.What i did was get a empty clean 3 litre bottle of milk.put half water in aproximately then filled the rest with antifreeze,i got a funnel use a pop bottle if no funnel and just cut bottom off, then proceed taking the top cap off and start filling till it reaches the top.You should just have enough left to fill the reservoir near to the full mark.reservoir= the small bottle next to your radiator.
The steps that are necessary to install a towel radiator vary depending on the model of the radiator and the space that you're looking to install it in. For the most accurate instructions, consult the instruction manual for your particular radiator, or contact the radiator's manufacturer.
There are 11 steps on how to change a radiator in a 2000 Mercury Mystique 2.0 liter engine. Some of the step-by-step instructions are to first squeeze the hoses to check for deterioration, if the hoses are swollen replace them, and then replace the hose clamps.
given that you have general knowledge on socket tools/wrenches. all you need to do is locate the drain pipe usually on the bottom or bottom side of the radiator. make sure its fully drained so you dont make a big mess. take off the fan cover. locate the bolts holding the radiator in place remove said bolts. remove said radiator do steps in reverse to replace. congratulations you replaced a radiator!!! well done. p.s dont for get to refill the radiator ;)
The torque specs for the head bolts on a 1997 Toyota Corolla goes in three simple steps: step one- tighten the bolts in the the correct order to 22lbs step two- in the same order, turn each bolt 90 degrees step three- go through and again in the same order turn each bolt in an additional 90 degree.
There are fourteen steps on how to replace the water pump in a 2004 Jeep Liberty Sport 2.4 liter 4 cylinder. Some of the step-by-step instructions are set the drain pan underneath the radiator's drain plug, drain the radiator, and then use a wrench to twist the radiator plug counterclockwise.
Get your new sway bar and you will see what has to be taken loose to remove and reinstall it.
what are the correct steps to remove the serpentine belt that runs to the alternator on a 2001 Toyota AvalonWas that an ANSWER!? I assume the question is, "How do I remove and replace the serpentine belt on a 2001 Toyota Avalon". (You can remove it with a good sharp knife!)
Drain the radiator. Remove the top hose, and the water inlet. Remove the thermostat from under the inlet, and replace it. Reverse the steps to finish the installation.