0
How do you remove and replace your door ajar sensor on your 2000 ford ranger?
Wiki User
∙ 16y ago
Pull the door panel off, remove the door latch assembly from inside the door, and replace the switch which is hold onto the latch with one screw on the backside of the latch.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How to remove Ford Ranger rear window?
How to remove 2000 ford ranger rear window. Need to replace would like to replace with a sliding window need instructions how to do it
Is there an dpfe sensor on your 2000 ranger?
yes
How do you replace the Rear o2 sensor on 2000 gmc jimmy 4x4?
Remove the vacuum hose from the O2 sensor. Remove the wiring harness. Remove the O2 sensor retaining screws. Reverse the process to install the new O2 sensor.
How do you replace front wheel bearings on a 2000 Ford Ranger?
how do i replace front wheel bearinbs on 2000 ford ranger 4wd
How do you change the co2 sensor on 2000 ford ranger?
What is a carbon dioxide sensor?
How do you remove the dash from a 2002 Ford Ranger?
How do your remove the dashboard on a 2000 Ford Ranger?
How many wires on a water temperature sensor for a 2000 ford ranger 4.0?
There are either two or three wires on a water temperature sensor for a 2000 Ford Ranger 4.0.
How do you replace a wheel assembly on a 2000 Montana with out cutting the abs wires?
You need to remove the hub assembly and replace it. It consists of bearing, studs and speed sensor. The wires are attached to a connector which is clipped to sensor shield. You cannot remove sensor on Montana without removing the hub. The sensor is a part of assembly.
How much is it to replace camshaft position sensor on a 2000 Chevy Malibu?
if you do it yourself,you only pay for sensor!! to change sensor on a v6, remove power steering pump and set aside do not remove hoses,sensor is under pump!! remove hold down bolt then wiggle it out!!
How do you change the fuel level sensor in a 2000 Impala?
To change the fuel level sensor in a 2000 Chevy Impala, first close the gas and power lines. Remove the wiring and then drop the car tank. Remove the old fuel level sensor and replace it with the new one.
How do you replace an o2 sensor on a 2000 s10?
Unplug and remove the old one. Screw in the new one and plug in the wires.
How do you replace a knock sensor on a 2000 Chevy 6.0 step by step?
how to replace a knock sensor on a 2000 Chevy 6.0 step by step
