answersLogoWhite

0

Question isn't all that clear. If you are asking about removing the moveable arm rest, you pry out the plastic plug in the hinge area. That will reveal a locknut which must be backed off and removed.

User Avatar

Jayde Bins

Lvl 10
2y ago

What else can I help you with?

Related Questions

How do you remove front arm rest seat for Toyota highlander 2002?

Question isn't all that clear. If you are asking about removing the moveable arm rest, you pry out the plastic plug in the hinge area. That will reveal a locknut which must be backed off and removed.


How do you remove the driver door panel on a 2002 Chevy Malibu?

Using a screw driver, remove the screws and the clips in the panel of the door and remove the panel gently. Remove any wiring connectors between the panel and the door, then remove the panel the rest of the way.


How do you remove the head rest for repair?

how do you remove the head rest for a sport track


Can a 7 passenger Toyota sienna be converted to an 8 passenger van?

No, not unless you replace both second rear side seats. or remove the center arm rest. I own a 8 passenger version and It doesnt have arm rest on the seats.


How do you take the door panel off a 2002 Kia Spectra?

First, use a screwdriver and remove the screws, and remove the clips. Next, gently pull the panel, and remove any wiring connectors, then pull the panel off the rest of the way.


In the morning only mornings you have trouble starting your Toyota highlander and to get it to start I keep the rpm high press gas until it starts. The rest of the day it is fine?

if the car sits over night.. it may take a little longer in the mornings to get going. for instance if its cold.. u wait until it heats up.. do u see where im comin from? i work in the garage at Toyota of Easley


How do you remove the front door panel in 1991 Toyota Previa?

remove the screw in the door handle get a pry bar flat and insert it on the side top part and pop it open ,remove the top ,remove three screws that hold the bottom portion of the panel { it;s a two part panel} then pry the rest of the panel out that it...


How do you remove a steering wheel on a 2002 cavalier?

Steering wheels are hard to remove. A tool called a steering wheel puller needs to be used to remove the steering wheel. It removes the steering wheel by applying pressure to the middle and pulling the rest of the wheel up.


How do you remove a 2005 Toyota Camry door panel?

Using a screw driver, remove all the screws from the panel of the door and unclip any clips holding the panel to the frame. Pull the panel away gently and remove any wire connectors and pull the panel off the rest of the way.


When was This Moment Is the Rest of Your Life created?

This Moment Is the Rest of Your Life was created in 2002.


How can you remove the drivers side inside door panel from a 1996 Toyota Tercel 2 door because something fell inside the panel?

How do you remove 96 Toyota Tercel door panel If you are still trying to find out how to remove inside door panel for '96 Toyota Tercel, I just went through the very same process on a '99 Toyota Tercel. 1. Remove window crank (it has a kind of 'bent wire' c-clamp, which holds it onto the window crank shaft).2. Pry upwards the top plastic cover to the arm rest (this is a plastic coated foam rubber piece, on which you rest your arm).3. Remover the two now visible screws which fasten the arm rest onto the door.4. Remove the one screw fastening the inside door handle.5. With a blunt tool, gently hit the inside door handle in a forward direction (towards the door hinge). This will release the door handle from the door.6. Pry between the door panel and the door, to unsnap the snaps holding the door panel in place.7. Finally, lift door panel out and up to remove it from door.


How do you remove and install the inside door latch on a 2002 Toyota Camry?

AnswerMy r/s int dr handle broke on 2002 Camry. Cost from dlr for part was 35.00. TO REPLACE: Remove door panel.Phillips screws(under rubber caps) & Plastic pop ins.Under arm rest insert rubber pops out exposing screw too. After door panel is down door handle is exposed.Tricky part is small plastic piece in center of handle that pops out exposing mounting bolt. Remove that and you are home free.Then just disconnect two small pieces of linkage and handle is out.Do all in reverse for reinstall.