from inside the boot, remove the side flap cover. around the light area you will see a plastic looking wing nut, remove this and then from the outside the car standing at the side pull the light hard at each end and it should just pull out as it is held in with what looks to be 2 ball joint pins. not much room to play with when it is out tho!
I have an estate, so the procedure might be slightly different on a hatchback, but not by much. The rear light cluster is attached via a screw behind the facia panel at the back. You will need to remove the plastic panel in the boot behind the light cluster and unscrew the unit before you can remove it to change the bulb.
remove the gage cluster the bulb is on the back of the cluster
IN THE TRUNK, REMOVE PANEL NEAR REAR LIGHTS. IF THE BACK OF THE BULBS ARE VISIABLE THEY ARE EASY TO REMOVE. IF NOT, CHECK FOR SCREWS THAT HOLD THE TAIL LIGHT CLUSTER IN PLACE. REMOVE SCREWS, REMOVE CLUSTER, REMOVE BULB. I HOPE THIS HELP. GOOD LUCK.
remove the trim panel around the instrument cluster then remove cluster. On the back of instrument cluster are the bulbs just turn them half a turn and they come right out.
Yes,first remove the top of the dash,then the bezel that covers the cluster and the radio and such,unplug the cluster, remove the screwes that mount it,look at the back of the cluster and twist the little bulb holder.
You hav to remove the inst. cluster and them disassemble it (just remove the back plate) and you will find the bulb in there.
Remove 2 7mm bolts on instrument cover plastic. remove this part exposing the 4 7mm bolts that hold in the cluster then carefully remove instrument cluster from dash. On the back of the cluster you can remove the bulbs by turning them counter clockwise and pulling them out. Bulb number 194
Remove the dash and remove the instrument cluster, the lights are in the back of the cluster.
Remove the dash cluster to gain access to the back of the cluster to change the bulbs.
Sounds like the light bullb\bulbs for you gauger cluster is out. You will have to remove the cluster to get to the back of this to change the lights.
Unscrew both screws on trim around light Then unscrew the light Remove bulb Change and then screw back in
Try to reach up from underneath but if you dont have room or cant reach it then remove the trim around the instrument cluster and heater (all one piece) unscrew instrment cluster and carefully remove the cluster the lights are in sockets that are removed from the back