Want this question answered?
its located i believe on back floor in the centre under the carpet?
i have the same issue. i need to take the back seats out so i can put my fusion 6x9" in the parcel tray. I have only been able to remove the bottom of the back seats which come out first but not the back rests of the seats which should come out after the bottom has been taken out. There are two clips underneath the back seat at the front. (One clip for each seat). You only have to unclip them and you will be able to take out the bottom of the seats. Hope this helps ya
To remove the instrument panel from the 1998 Mitsubishi Eclipse, carefully pull back the pod. Take care not to lose any of the clips.
Just take out the speakers from the speaker box and make a new box for the speakers if they dont fit.
Remove the wiring harness from the back of your 2003 Mitsubishi Eclipse alternator. Loosen the alternator tensioner bolt. Remove the alternator belt. Remove the alternator retaining bolts. Reverse the process to install the new alternator.
* Remove the rear seatback * Remove one of the rear quarter trim panels * Release the four plastic push-in retainers that secure the rear parcel shelf disengage the rear seat belts from the slots in the parcel shelf and remove the parcel shelf * To disengage either rear speaker push down on the tab on the front of the speaker spacer lift the speaker and pull the speaker forward.Unplug the electrical connector and remove the speaker from the car
Possibly, remove the back seat and see for yourself.
The shelf in a hatch back is a partial shelf. A parcel is a package.
Begin by removing the wiring harness from the back of your headlight. Remove the headlight assembly retaining bolts. The headlight assembly will come out.
I had a very hard time with my back speakers. I had to remove the back seats so I could remove the parcel shelf and speakers. Then I did the same thing in reverse with my new speakers lol. I am NOT looking forward to doing the front speakers/tweeters. Haha Khloe :)
To install the Mitsubishi Eclipse driver mirror, you will need to remove the interior door panel on the driver's side. Then, remove the cover for the mirror screws. Remove the screws and wiring and remove the old mirror. Replace the wiring and screws as you add the new mirror to the car. Then place the cover and the door panel back on the vehicle.
go back to the musum and you will get a parcel