There are two 14mm bolts along the bottom front of the bench portion of the back seat that should be removed first. After removing the bench portion there are two 10mm bolts on the bottom left and right side and also two 10mm bolts behind the armrest/trunk access door. After removing all four bolts, lift up and out to remove.
Seat bottoms just pop up, has clips. seat back have bolts to remove. Need to remove bottom first.
Get your sawzall out and remove tank by cutting trunk off. THis should reveal pump which can be removed with large hammer. -------------- Ha. Remove the back seat, the fuel pump is located underneath the back seat.
The fuel pump is located under the back seat ... You will have to remove the bottom portion of the back seat - 1 bolt on each of the floor hump ... Remove the cover plate and you will be able to see the pump. You will need a manual to understand how to actually remove the pump.
How to replace a fuel pump on a 1993 Nissan altima?" Remove the back seat. The fuel pump is located under the seat. Will either unbolt or have a locking ring, remove whichever the case may be. Lift fuel pump out of tank, install new one with new gasket.
You need to remove the rear seat, then remove the package tray.
there are two bolts in the back of the seat. remove them and then slide the seat back about an inch and remove
how to remove 2004 scion back seat
To remove the back seat of a Skylark, reach into the area between the back and the seat and pull up on the seat. The back part of the seat is bolted in and will require a socket wrench to remove.
well the first thing is to remove the lower seat. It has two clips near the front of it . Remove the lower seat now. Next remove the side panel right above the back seat. Now you have to remove the bolts for the seat belts, it holds the back part of the seat in. move the back part of the seat up towards the back window. You should hear the seat come loose. Now when you put the seat back in don't forget to pull the seat belts back though.
To remove the back seat of a 1998 Toyota Corolla, you will need to remove the carpet to expose the bolts for the seat. Then, loosen the bolts by removing the nuts. You can then remove the seat.
First you remove the lower back seat, and the bolts that secure the upper will be exposed. Remove them and lift out upper back seat.
the back of the seat is the front of the trunk. To remove the rear seat back you first have to remove the two bolts just under bottom seat assembly. Bolts are located at the botton of lower seat, about between your ankles if you were sitting in the seat, one on each side. Then remove bottom seat assembly. Then remove seatbelt bolts that hold seat back assembly, lift straight up on seat back and remove.