Two mounting bolts at rear of caliper - then slide caliper off rotor
5/16" allen
1. Remove the brake hose to caliper bolt from the brake caliper. 2. Remove the brake hose from the brake caliper. 3. Remove and discard the 2 copper brake hose gaskets. These gaskets may be stuck to the brake caliper and/or the brake hose end. 4. Cap or plug the opening in the brake caliper and the brake hose to prevent fluid loss and contamination. 5. Remove the 2 brake caliper pin bolts. Remove the park brake cable from the caliper. 6. Remove the brake caliper from the brake caliper bracket.
Jack up the car and take off the tire. After the tire has been removed, decompress the brake caliper and remove the brake shoes. Remove the 2 bolts attaching the caliper and remove the caliper. There are 2 more bolts left, they hold the caliper mount on. Remove those 2 and the Rotors wil come right off
Lift the vehicle on a jack, remove the tire and set to the side, remove the brake shoe/caliper, and remove the old brake pad. Throw away the old pads, put in a new brake pad, replace the brake shoe/caliper, replace the tire, and lower the vehicle to the ground.
Lift the vehicle on a jack, remove the tire and put it aside, remove the brake shoe/caliper, and remove and dispose of the old brake pad. Put in a new brake pad, replace the brake shoe/caliper, replace the tire, tighten the nuts, and lower the vehicle to the ground.
left on brake bleed valves
Should be of the "peel off" type Remove wheel Remove caliper mounting bolts Slide caliper off rotor Rotor should slide off hub
On a 1994 Buick LaSabre why does the engine continue to rev up while driving even when the brake is applied ? or when driving why doesn't the engine return to idle when the brake is applied? I would check for a vacuum leak
What size alien wrench need to take off brake caliper 1996 Buick le sabra
Remove wheel, remove the bolt holding brake hose to the caliper, remove the two pins that hold the caliper to the caliper bracket using a 3/8" allen wrench, remove caliper. Inspect brake pads and brake hose for damage, replace if necessary. Install new brake caliper in reverse order. Bleed system.
Remove the brake caliper and hang it out of the way, then thread 2 8 mm bolts into the holes provided on the disk. Screw them in and the brake rotor will come off.
You have to remove the brake caliper before you can remove the brake pads. I recommend you use a piece of wire and tie the caliper up to the spring to hold it. Now that the rotor is out of the way, you can remove them by sliding them out.