2 WD? Remove wheels
Remove caliper mounting bolts
Slide caliper off rotor
Remove rotors if they are the "peel off" type If not "peel off"
Same as above, but remove center dust cover
Remove cotter pin
Remove washer and nut
Slide rotor off spindle (bearing will slide out first)
You will need to remove the tire and wheel from your 1995 Chevy Cheyenne. Remove the brake assembly. Tap on the rotor with a hammer or mallet. The brake rotor will slide off. Reverse the process to install the new brake rotor.
You have a warped brake rotor(s). Resurface or replace the effected brake rotors.
There should be two rotors if your truck is 2wd. They are located where the brake pads clamp to. Rotors are also called brake disc. It's the round disc between the brake pads.
A 1977 Chevy pickup truck would have rotors in front and drums in the rear
you get a towel and clean
If the truck has disc brakes on the rear then the park brake shoes are located inside the rear rotors. You have to remove the brake calipers, pads and rotors to access them
Need to know if it is a 4+2 or a 4+4.
There's 3 on that truck. You have 1 in behind both front brake rotors and 1 on the transmission tail shaft.
put the parking brake in, then put the truck in 1st gear pop the dash cover off and then remove bolts from stereo.
Remove the two slider/anchor pins using a 3/8" Allen wrench and the caliper will come off.
The front rotors are out of round are warped. Turn are replace rotors and be sure to replace the brake pads even if thay look good. I would also check the tie rods too.
Most probably due to worn rotors/pads.