0
How do you remove crankshaft position sensor on a 04 Hyundai xg350i?
Wiki User
∙ 6y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where is the crankshaft position sensor on a 2002 Hyundai accent?
Where is the crankshaft position sensor on a hyundai accent 2002
How do you remove a Crankshaft Position Sensor?
how to remove crankshaft position sensor from 91 Buick Regal
Where is the crankshaft position sensor on a 2000 Hyundai Tiburon?
it is on the tranny.
Where is crank shaft position sensor on Hyundai accent 1.3l 3 door 1998 model?
The HyundaiÊ1.3 liter engine crankshaft position sensor can be found on the back of the engine. You will need to remove the rear engine cover in order to access the crankshaft position sensor.
Where is the crankshaft position sensor on a 98 Hyundai elantra?
The crankshaft position sensor is located on the front side of the engine block near the flywheel/driveplate
Where is the crankshaft position sensor on a Hyundai Elantra 2001?
The Crankshaft sensor is located on the front side of the engine block,near the flywheel/driveplate.
Where is the crankshaft sensor on a 1998 Hyundai elantra located?
The crankshaft position sensor is located on the front side of the engine block near the flywheel/driveplate
Where is the crankshaft position sensor on a 2004 Hyundai sante fe?
Behind the timing belt.
Where is the crankshaft sensor?
98 Hyundai crankshaft positioning sensor location
Where is the crankshaft position sensor located on a 1996 Hyundai accent?
Crank Angle Sensor (location)i own a 98 Hyundai accent and the crankshaft position sensor is located just underneath the far right spark plug if your looking from the front of the car,about 5"-8". hope this helps.
where is the crankshaft position sensor on a 2004 hyundai sonata?
its behind the timing cover and reads a plate between two crankshaft sprockets
Where is the camshaft position sensor on a 2002 Dodge Intrepid?
CRANKSHAFT POSITION SENSOR The crankshaft sensor is located on the passengers side of the transmission housing, above the differential housing Crankshaft Position Sensor The bottom of the sensor sits above the drive plate REMOVAL Disconnect electrical connector from crankshaft position sensor. Remove sensor mounting screw. Remove sensor. INSTALLATION Install sensor and push sensor down until contact is made with the transmission case. While holding the sensor in this position, install and tighten the retaining bolt to 12 N·m (105 in. lbs.) torque. Connect electrical connector to crankshaft position sensor.
