To remove the door locks on a 1991 S10, the door panel has to be removed. There are bolts inside that hold the lock mechanism in place.
You have to knock out the small round retaining pin and then it comes off.
remove door panel and small round plug from door jam to access nuts
there is a small clip between the handle and door panel that u have to remove it is easy if u have a small pick to hook it with then to install just place clip on handle and push on the window regulator shaft.
There is a small clip on the side of the leather handle. Pull this clip out, then the shift handle will come off.
remove the outside handle by lifting the handle up and removing the small clip in the underside of the handle The inside door handle? remove the screw pull towards the front then out and release the clips holding the lock and open rods
To remove the handle the inside door panel has to come off,with the window up.there is a small bolt insde and one at the end of the door by the handle take those two off and the linkage inside...yes you need small hands.
Assuming its not a power window...and you wnat to remove the cranking handle... Possibility: look behind the handle for a U-shaped spring clip that fits into slots on the handle "sleeve". This clip will have two small tangs that can be levered to push it back out of the slots in the handle.
Assuming you are referring to the outer door handle, remove the inner door panel and look at the back of the handle. You will see a couple of steel rods attached to the handle, remove these(they just unclip)and move them out of your way. You should be able to see a couple of small nuts holding the handle to the door. Remove these and the handle can be pulled out of the door from the outside.
remove small round plastic cap behind inside door handle, remove the screw, remove screws from door panel edges, starting at the bottom..pull the panel straight off the door. a door trim tool (if available) may be used to release the clips behind the panel
On the inside of the door by the rear lip of the door there is a weatherstrip. under the weatherstrip kinda parellel to the handle there is a small black cover. Remove the cover, take a hook tool and reach in about 3-4 inches and drag the tool back to you with the pointy end towards the handle and pull on the small rear part of the handle. you want to angle the hook tool towards the inside of the door a little. once the small part of the handle is out the rest comes out like every other stupid vw handle. wiggle it.
If you push the panel away from the handle and look down behind it you'll see a small snap ring holding the handle to the stud. With a curved scribe or something like that you can pull that snap ring off and the handle will slip right off.
Zero Insertion Force socket, the ZIF socket was designed by Intel and includes a small lever to insert and remove the computer processor.