Auto Parts and Repairs
Door Panels and Handles
Ford Explorer Eddie Bauer
Honda Civic DX

How do you removal the door handle from a 98 Saturn?

949596

Top Answer
User Avatar
Wiki User
2015-07-15 21:14:15
2015-07-15 21:14:15

remove the outside handle by lifting the handle up and removing the small clip in the underside of the handle The inside door handle? remove the screw pull towards the front then out and release the clips holding the lock and open rods

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

how do you install spring on interior door handle of a 98 chevy pickup

User Avatar

Need to know inside or outside door handle.

User Avatar

Door Panels Removal & Installation 1. Remove the sail panel (Front Doors Only). 2. Remove the door panel by carefully lifting the panel upward to release the retaining clips. 3. Remove the electrical plugs that control the windows, exc. 4. Repair handleThe installation is the reverse of the removal.

User Avatar

You will need to remove the inside door panel, by prying outward on the door panel retaining clips. When the door panel is removed the door handle assembly will be visible. Remove the door handle retaining bolts.

User Avatar

no, 2010 doorhandle is completely different... only doorhandle you you put on are 98-04

User Avatar

The door handle directions for replacement on a 98 Sebring can be found in a service manual. The manual ca be purchased through a local auto parts, or possibly could be checked out at your local library.

User Avatar

How do you take the door panel of a sl Saturn 98 window off track.

User Avatar

AS YOU PULL UP ON THE HANDLE, PUSH IN ON THE LID..PRESSURE NEEDS TO BE REDUCED ON THAT DOOR BEFORE IT OPENS..TRY THIS! !

User Avatar

Go to this link: http://www.lincolnsonline.com/tech/00148.html

User Avatar

Airbags are not in the door, but rather in the seat. Should be no additional issue at all.

User Avatar

The screws are around the door handle and the door latch pop out the plastic behind the latch their may be a screw underneath the door panel and lift the window switch cover out from the bottom next to the handle striaght up off the metal clip slide it through the door then just pop it off the retainers

User Avatar

Most likely the outside handle is broken. The ear that the rod connects to breaks off. Only solution is to replace. Remove the inside panel and there will be one or two bolts holding the handle in. ON the back door there should only be one rod connected to it.

User Avatar

please I have a 1998 Saturn coupe SC 2 both power door locks out the same time 3 weeks ago. Is the fuse box for door locks under the hood or in the auto. next question could it be the switch on the door behind the lock itself, but why both out the same time? thank you very much.

User Avatar

the door speakers you must remove the door panels to get to them. the whole thing pops off but the door handle has one bolt and you have to take of the window crank (if you dont have automatic windows)

User Avatar

Saturn sc takes 1.5 pounds of R134a

User Avatar

Where is the door lock module for 98 chevy Remote

User Avatar

this is actually the easiest thing to do. DO NOT pry it off. under neath the door panel there shold be 2 screws remove those. Then where the inside door handle is there is a thing you pop off and there is a screw under neath there. After you remove that screw, remove that piece from the door handle, so you can see the inside of the door. Then just lift up from the bottom of the door and it pops right off.

User Avatar

Door Panels Removal & Installation 1. Remove the sail panel (Front Doors Only). 2. Remove the door panel by carefully lifting the panel upward to release the retaining clips. 3. Remove the electrical plugs that control the windows, exc.The installation is the reverse of the removal.

User Avatar

How do you get to the ac actuator door on a 98 Lincoln town car

User Avatar

take it to a Saturn dealer they will do it for free

User Avatar

On my 96 and 98 I removed plastic by handle. Then screws at very bottom of panel now lift up on it Install just the opposite

User Avatar

Successfully done on a 98 Eclipse R/S w/o power locks or windows. The replacement exterior door handle typically comes with a new rubber/plastic seal and a new lock cylinder retaining clip.First, remove the 6 screws holding the interior molding to the door (x2 screws at the hinge, x2 screws at the jam end, x1 screw holding the molding at the interior door handle, x1 screw under a plastic cover in the door well (place to grab when closing door)). Remove the retaining clip from the window handle (if present) and remove the handle.Gently remove the interior door molding that's held in place by plastic clips. Roll up the window the whole way. Remove the bolt on the jam side of the door adjacent to the handle. This is one of 2 screws that holds the handle on. The other handle is located inside the void within the door. Peal back the plastic barrier on the latch side of the door to gain access to the bolt on the interior side of the door. To remove this bolt, I used vice grips to hold a 1" long 10mm hex bit socket to remove the remaining bolt. Once the bolts are removed, disconnect the x2 connecting rods (x1 for latch, x1 for interior lock switch) and remove the handle.Remove the lock cylinder from the old handle and install in the replacement handle. Seat the new handle in the door and install the x2 bolts to hold in the handle. Once the handle is secured, reconnect the x2 connecting rods and reinstall the interior door molding, screws and window handle.

User Avatar

How do I replace heater core on 98 Buick lesabre

User Avatar

There are 2 screws in the bottom of the door and 2 more under the door handle in the inside of the car just pop it off at the seems and screws will be inside pop panel off and unplug the power locks


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.