0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you remove the rear door panel of a Mitsubishi 380?
To remove the rear door panel of a Mitsubishi 380, first one must remove the power door/lock switch. Next, remove the door handle bezel followed by the screw that was hidden behind that bezel. Finally, remove the screws located by the armrest handle. The rear door panel is now free to be removed.
How do you fix faulty indicator on Mitsubishi 380?
380 indicator switch
What is the tire pressure for Mitsubishi 380?
31 psi. Recommended Tyre pressure is written on a plate inside driver's door near hinge.
Where is fuel pump relay located on a Mercedes 380 sl?
Fuel pump relay on a 1981 380 sl is below the glove conpartment box,remove platic panel should be on raghit side
Where is the turn signal flasher on a 1984 Mercedes Benz 380 SL located?
It is behind the instrument panel - you must remove the steering wheel, then the instrument cluster to get to it
Are you 380 volt panel what size cable use?
With out knowing the amperage rating of the panel, an answer can not be given.
Can you get a Mitsubishi 380 VRX in Manual?
The Mitsubishi 380 was originally released in 2005 with two available transmissions available, either a 5-speed manual or a 5-speed tiptronic semi-automatic. However the manual was only available on the base model (the '380') and the VRX. All the other models had the auto as standard, while the 380 and VRX could be optioned with it.
Where is the fuse panel on a 1982 Mercedes 380 sl?
fuse panel is on rhs footwell near the accellerator on rhd models
During which model years did Mitsubishi offer the Magna?
The Mitsubishi Magna was available for purchase between the years of May 1985 and September 2005. It spanned 3 generations of Motorcar before being replaced with the Mitsubishi 380.
How do you remove the firing pin from a sterling 380 auto?
You need a gunsmith
How do you run 220v from 380 fuse panel Ship Supply is 380 and I need to operate 220 motor.?
You can get a buck / boost transformer which will step down the voltage. What will be important is phase supply.
How do you make a homemade silencer for a 380?
.380 colt stick a pencil in the barrel, jamb a potato over the pencil onto the barrel, remove the pencil
